Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
COOLING SYSTEM
WATER PUMP BASE
IMPELLER KEY
Use with 47‑43026 series long vane impeller.
Fits MCM Alpha One Gen II & various O/B applications.
INSERT CUP
Fits MC‑I & R drives w/o flush screw in housing (1970‑1984)
WATER PUMP IMPELLER
Priced individually, sold @ multiples of 2
FACE PLATE
Fits MCM & Outboard applications. This impeller uses a brass insert. An alternate
salt water applications.
WATER PUMP IMPELLER
FACE PLATE
Fits 30/40/45/50/60 FourStroke Bigfoot, 60 (3 cyl.) BigFoot, 75‑125 (all 3 & 4
cylinder models, USA A996142 & above and BEL 9483121 & above), 75/90/115
FourStroke, 150 EFI FourStroke, V‑200 (3.0L) DFI, V‑225/250 (3.0L) and
MerCruiser Alpha One Gen II drives.
IMPELLER KEY
WATER PUMP GASKET
Fits MCM I/R/MR/Alpha One & various O/B applications
Priced individually, sold @ multiples of 5
Priced individually, sold @ multiples of 5
US Quicksilver Product Guide
847