Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
STEERING
ATTACHING KIT
ATTACHING KIT
For port or starboard entry.
For thru tilt tube steering only.
Fits various Mercury/Mariner 8/9.9/15 hp. 4‑Stroke (323 cc) and also fits the 20/25
Fits Force 75‑150 hp. outboards prior to serial number 0E093700.
2‑cycle (1984 & newer) outboards.
Will also work as the port entry attaching kit for the Mercury/Mariner 8/9.9 hp.
TRANSOM MOUNTED STEERING KITS
FourStroke (MY 2005 & newer) when used with the Ezy Glide stick steering
system. Do not use this link rod with this engine when using the traditional rotary or
rack steering systems.
For single cable‑single engine outboard applications.
ATTACHING KIT
CLEVIS KIT
Starboard cable entry.
Fits various Mercury/Mariner 35 thru 60 hp. outboards. See application chart for
For use with transom mounted bracket.
specific engine models.
Fits Mercury 4,5 hp. and Mercury / Mariner 20, 25, 40 (3 cyl.) and 70 thru 200 hp.
outboards. Also fits 50/55/60 hp. (3 cyl., USA 0D000750 and Newer, BEL 9682500
LINK ROD ATTACHING KIT
and Newer).
CLEVIS KIT
Link rod, screw, washers & nuts for use with a starboard entry attaching cable.
Fits Mercury/Mariner V‑6 outboards USA 5464486 and above, Force 75‑150
outboards 0E093700 and above, 75‑115 FourStroke 1B366823 and above, and
For boat‑mounted mechanical steering and non‑threaded cable end.
the 150 EFI FourStroke 1B905505 and above..
Fits Force outboards.
US Quicksilver Product Guide
305