Logo
FULL SITE MENU

Search results

  1. 1

    What side

    what side should a outboard be what side should a outboard be placed on when you move it from one place to another??? so it wont get damaged
  2. 1

    1974 70hp johnson outboard

    hello i bought a new power pac hello i bought a new power pack but i think that maybe its a couple years newer than mine the only difference is that the cover plate for my one thats on my motor has four screws to srew the cover on and the one i got only has two but it has the same number...
  3. 1

    1974 70hp johnson outboard

    hello i have a problem when i hello i have a problem when i go to start my motor it wont turn over when i turn the key its just silent when i hook up the battery jumper to it it turns over and then when i stop and try again it does it again connections are clean and tight battery is fully...
  4. 1

    1974 70hp johnson outboard

    hello well after alot of rain hello well after alot of rain in my area yesterday i went out to run my motor and take a ride but now my motor wont start has good compression rebuilt carbs but i took the spark plugs out and i wanted to see if i had spark so i had some one just tap the key so i...
  5. 1

    Soaking carbs or not

    ive been reading alot of forum ive been reading alot of forums on here and iboats and some other sites and alot of people say soak the carbs in carb cleaner or boil in water and alot of others say that it is not good for the carbs to be totaly sumerged in carb cleaner and im wondering whats...
  6. 1

    1974 70hp johnson outboard

    hello i have an issue with my hello i have an issue with my motor and im trying to narrow it down to either starving for fuel or air how do i go about narrowing it down my primer bulb and fuel lines are ok thanks for any help
  7. 1

    1974 70hp johnson outboard

    hello i have noticed some milk hello i have noticed some milky white substance on the butterflys on the choke and i was wondering if this means that water is getting in my gas
  8. 1

    Prop

    hello i have a 1974 johnson 70 hello i have a 1974 johnson 70 h.p on a 17 ft runaboat it does flat out about 28 mph my prop is chewed up and old probably the same one from when it was built if i bought a new prop would this increase my top end i was planning on buying the same size thanks for...
  9. 1

    1974 70hp johnson outboard

    i finally got my motor running i finally got my motor running right after a while working on it but now when i go to power up it will go to 3000 rpms then it will take a little bit to go higher you really have to baby the throttle to get it up to a good speed could this be that the floats are...
  10. 1

    What does this mean

    hello i have a 1974 johnson 70 hello i have a 1974 johnson 70 hp and i put new carb kits on all three carbs and new spark plugs gapped a .30 and now i noticed that on my top carb there is alot of gas coming from the tube in the middle of the carb and the other two gas only comes out of that...
  11. 1

    Spark plug gap

    hello i was wondering what my hello i was wondering what my spark plugs should be gapped to for a 1974 70hp johnson model 70esl74m thanks matt
  12. 1

    Floats

    i was wondering if the floats i was wondering if the floats arent adjusted to 3/4 of an inch if this would cause power loss and make the motor die thanks for any help
  13. 1

    Compression

    hello my question is if a moto hello my question is if a motor has bad compression if it would still make your boat drive or if it would just die or not go anywhere
  14. 1

    Gaskets

    "does anyone know where i can "does anyone know where i can get a full gasket kit on the carbs for a 1974 johnson 70 h.p. thanks, matt"
  15. 1

    Need help

    my motor would die when i try my motor would die when i try to get on a plane i thought if i cleaned my carbs really good and carefull that it would fix my problem and i put my boat in today to see if that was it and now it just dies when i put it in gear and i put everything back on right i...
  16. 1

    Can anyone help me please

    "i put my boat in the water to "i put my boat in the water today and i went to get on the throttle and it wouldnt pass the idle spped i would try to get on it and it would want to die so i was wondering if it could be that the carbs need cleaning cause when i got on the gass i had my friend...
  17. 1

    Power problem

    my motor is idiling fine but w my motor is idiling fine but when i go to get on a plane it wants to die like its starving for fuel but i had someone sit their and pump the bulb to see if it was going flat and it wasnt i got it up on a plane with starter fluid being sprayed into the carbs i was...
  18. 1

    Power problem

    "i put my boat in the water to "i put my boat in the water today and i went to get on the throttle and it wouldnt pass the idle spped i would try to get on it and it would want to die so i was wondering if it could be that the carbs need cleaning cause when i got on the gass i had my friend...
  19. 1

    Broken bolt

    i have a 74 johnson 70 h.p and i have a 74 johnson 70 h.p and the bolt that holds the piece to keep the motor up broke and the bolt is still in the hole and iwas wondering how to go about drilling the bolt out or if there is a better way to get the bolt out and its not a tiller you can either...
  20. 1

    Water pump

    hello let me start by saying i hello let me start by saying i love this site and that i think its great that all you guys take time out of your days to help people out you dont see that anymore but anyways i bought a boat and it has a 1974 johnson 70hp on it and it looks like their is stuff...
Back
Top