Logo
FULL SITE MENU

Recent content by zion

  1. Z

    1990 johnson tilt and trim problem

    Hi guys I have a 1990 Johnson that the tilt and trim unit just stopped working proper, the motor is working fine, the trim rods do go up and down but only when i release the upper end of the oil assembly line on the center cylinder, when the oil assembly line is tight, only one of the trim rods...
  2. Z

    89 Evenrude no spark

    well guys, the motor at first when i tried to fire it up it would give me a hard time to get going, but once i was able to turn it on and go out and shut it off, no matter for how long, it would fire up right away. The deal is that two weeks after the last time i use it, i tried to take it out...
  3. Z

    Evenrude take alot to start

    "hi guys, I have an evenrude t "hi guys, I have an evenrude that it takes from 20 to a half an hour to start. After it start and then i turn it of. I then try to turn it on, and it turns on with out a problem for the rest of the day. And this happens every time i use the boat."
  4. Z

    It wonbt shut off

    "Hi guys, I recently swapped a "Hi guys, I recently swapped a Johnson with an Evenrude engine. After finally getting it to run, when I turn the ignition key to shut it off the motor keeps running to the point that I have to pull the spark plugs cable to shut it off. What could be the problem...
  5. Z

    OMC trimtilt problem

    "I have an 800 omc stern drive "I have an 800 omc stern drive. When i swich it in reverse, the stern drive raise up and i can't move backward. }}"
  6. Z

    Upgrade points to electronic conversion

    "Can someone help, i was told "Can someone help, i was told that changing the points to electronic ignition will work better and will produce more horse power. what its there to this. I have a mid 80's, 302, 5.0, v8 175 h/p, ford. with clip cap ignition."
See more
Back
Top