Logo
FULL SITE MENU

Recent content by grimesinma

  1. G

    1992 30hp lower drive assembly

    I have a 1992 Yamaha 30hp outboard model 30MSHQ. I need to replace the lower drive and I need help with the correct replacement part number. Online research has come up with a part number 6J8-45300-04-EK. I understand that the "04" portion of the part number denotes a short shaft. All websites...
  2. G

    Ideas on how to get this bolt out...

    The bottom one holding the oil tank on. The bottom plastic housing lays right against the head. The housing has some give but I don't know if enough. Any suggestions?
  3. G

    2005 E90DPLSOR leaking oil

    My 2005 90HP ETEC engine (E90DPSLOR) is leaking 2-cycle oil. Any place to suggest looking for the source of the leak? What are the chances that I can replace something easy such as the oil tank and fix it with the motor still mounted on the boat? I am good with repairs and have lots of tools...
  4. G

    Prop shaft repair Evinrude E90DPSLOR

    Hi all, The place that I have my boat stored says that the lower unit needs to be repaired as the prop driveshaft is bent. It is a 2005 or 2006 E-TEC 90hp. I see online that the shaft itself costs about $450. Any idea on how much the entire repair might cost? Since the prop shaft needs to be...
  5. G

    E-TEC 90 "No Oil" faults

    I have a model E90DPLSOR that frequently gives me a "No Oil" warning which puts it into limp-home mode. Shutting the motor off and re-starting clears the problem. On any given outing this may happen ten or more times so it is more than just a small nuisance. I have verified that there is oil...
  6. G

    Fuel pump part number

    "According to the OMC parts ca "According to the OMC parts catalog for my model/year (4W69B: 1969 4hp Johnson), the fuel pump assembly is listed as a part number 381815. I'm looking at a similar fuel pump (OMC part number 397839...see attached photo) and it looks identical to my part. Does...
  7. G

    Fuel pump problem

    "Let me try this again. If yo "Let me try this again. If you disconnect the line going into the carburator, connect the fuel tank, squeeze the bulb and fuel comes out, that means there is no line restrictions right? Now if you then hand crank the motor in the same configuration and no fuel...
  8. G

    1969 Johnson 4hp fuel pump diagnosis

    "Hi all, Yesterday I got my S "Hi all, Yesterday I got my Seloc maintenance manual (I have a 1969 Johnson 4 hp model 4W69B). I have determined that: 1. The compression is good (whew!) 2. It is getting spark Now, I was using the procedure for diagnosing fuel problems in the manual...
  9. G

    How good are the Seloc repair manuals

    I have a 1969 Johnson 4 hp out I have a 1969 Johnson 4 hp outboard. The Seloc maual covers Johnson/Evinrude 1.5-40 hp 1 and 2 cylinder 2 stroke 1956-1970 models. I was afraid that too many models are covered and therefore not specific enough for my model.
  10. G

    1969 Johnson 4hp rope starter assembly

    "Yesterday I bought a 1969 Joh "Yesterday I bought a 1969 Johnson 4 hp outboard motor (4W69). It is missing the entire hand-starter assembly. Evidently people have been starting the motor using a rope with the cover removed. Does anyone sell the hand-starter assembly? This is the one that...
See more
Back
Top