Logo
FULL SITE MENU

Search results

  1. T

    1992 EVINRUDE 60 OPEN INJECTER HOSE

    I removed the oil injector tank, and I am premixing my oil and gas. But I have the hose that goes from the tank to the motor open. If I block it, the alarm goes off. I don't know if it affects how it runs with the hose open. Any suggestions.
  2. T

    1992 EVINRUDE 60 jumps out of drive

    Thank you, I had no clue that could happen.
  3. T

    92 EVINRUDE 60 how to turn off alarm

    Where is the temp sensor located? THANK YOU for your time..
  4. T

    1992 EVINRUDE 60 jumps out of drive

    I don't remember a bang, but the RPMs go up. No on changing the prop.
  5. T

    92 EVINRUDE 60 how to turn off alarm

    I had the lower end apart and installed a new water pump. I did not install it properly, so when I started it, the pump did not work. I took it back apart and repaired the problem. NOW the alarm goes off. How do you turn it off?
  6. T

    1992 EVINRUDE 60 jumps out of drive

    going along at a steady speed, and it feels like it goes into neutral. I put the shifter in neutral and back down into drive, and it works. I took the lower end apart and inspected the gears and everything looked ok.
  7. T

    fouled spark plugs

    no pictures just wet spark plugs . thanks for responding GOLD MEDAL CONTRIBUTOR. ADVANCED CONTRIBUTOR yes I know you are right I just needed to hear someone with experience tell me what I already thought it might be. This is my first time working on a boat motor and at 69 I am dealing with the...
  8. T

    fouled spark plugs

    surly there is something i can do to keep it from fouling the plugs and it will only start after i dissconnect the fuel line going to the motor. i crank on it for a few seconds long enough for it to clear out the excess gas from it and it fires up and runs until it is out of gas. with the fuel...
  9. T

    fouled spark plugs

    1992 Evinrude 60 fouling spark plugs it's been sitting for a few years I cleaned the gas tank and put fresh gas with 50-1 oil. I cranked it over with the plugs out and it looked like it was spraying gas out the plug holes. I put the spark plugs back in it and cranked it over with the fuel line...
  10. T

    lower end interchange

    well, I will have to take it as a lesson learned. so by the splines on the shaft, I have a much older lower end than I was told. could I use the body and put my gears in it because the lower part of mine is no longer there, the part that protects the prop? thanks for your time.
  11. T

    lower end exchange

    I drove 5 hrs almost to Arkansaw and picked up a Johnson lower-end. I'm looking at the end of the drive shafts and the Evinrude has 16 splines and the Johnson has 4 will changing the drive shafts make it work? Is there a special tool to install the gear and nut back on the driveshaft?
  12. T

    lower end interchange

    I have a 1992 Evinrude 60 with a bad lower end I was told that a 1993 Johnson 70 lower end would interchange and work on my Evirude. I am looking at the end of the driveshafts and they do not match the Evinrude has 16 splines and the Johnson has 4. Can I swap out the drive shafts and make the...
  13. T

    lower end exchange

    will a 1993 Johnson 70 lower-end fit on my 1992 Evinrude 60 motor
Back
Top