Logo
FULL SITE MENU

Recent content by jfields

  1. jfields

    E15rcrm Evinrude 15 hp - Fuel problem

    This motor runs good for a few seconds then shuts off like it isn't getting fuel. Sometimes it will run for 5 or 10 minutes. Here is what I have replaced new on it. All fuel lines on motor including the hose and primer bulb from tank to motor , New fuel connector from primer hose to motor New...
  2. jfields

    Model # A118149 Mercury 18XD question

    I Bought a Mercury 18XD # A118149 today. From what I can find out it is an 84 model.The man I bought it from bought it at an Estate auction. The motor has never been ran from what I can tell. It Still had tags on it and appears in show room condition. I checked all the basics and started it up...
  3. jfields

    Plastic piece that screws in block to hook outgoing water line to on 84 evinrude 15 hp

    Evinrude 1984 15 hp # E15rcrm I need to know what the plastic piece that screws into the block that hooks to the hose that squirts out the stream of water from the water pump back into the water is called. I said it screwed into the block , I am assuming it screws in. It broke off even with the...
  4. jfields

    1984 evinrude 15 hp # E15RCRM shifting help

    Disregard the blue arrow. The bolt that the red line is pointing to is what im wondering about. I can see on the other side of the black plastic piece that it looks like there was a washer or bushing there , plus it wasn't working properly. If you can , please explain that whole plastic piece to...
  5. jfields

    1984 evinrude 15 hp # E15RCRM shifting help

    I bought an engine with a lot of missing parts. Not sure if this is what its called but im calling it a shift lock hub. Its the black plastic piece that has a linkage screwed into it with a bolt in the middle. It sits beside fuel pump and under the timing plate. My question is this. Is there a...
  6. jfields

    84 evinrude wont idle without choke , And starter recoil question

    1984 Evinrude 15 hp. Been working on this motor a while got everything going but it wont idle unless choked. Did a carb rebuild , new fuel lines , and cam follower and roller. Runs good at higher throttle but wont idle unless choked. I took off the fuel pump and checked it. It seems to be good...
  7. jfields

    fuel line clamp?

    Ive been restoring an evinrude 15hp 1984 model. I had to replace the main fuel line Where it connects on the other side of where the fuel tank line hooks on and goes to the fuel pump. Should there be a clamp on it.There wasn't one on it just wondering.
  8. jfields

    1984 evinrude 15 hp rear latch removal

    The outside handle broke , I want to replace it but it looks impossible without removing thermostat housing or possibly more. Any suggestions?
See more
Back
Top