Logo
FULL SITE MENU

Search results

  1. T

    Evinrude 2010 ETEC 90

    Good Morning All, I have a 2010 90 ETEC that keeps randomly cutting off. In a given fishing trip the motor could potentially run all day without randomly cutting off or could potentially do it as many as 4 times. On the bright side, each time the motor cuts off it fires back up instantly...
  2. T

    2010 ETEC Electrical Issues

    Good Morning All, I have a 2010 90HP E90DSLISE. The motor will crank up and idle just fine for extended periods of time. However, once it warms up it will periodically shut off more commonly on idle. Often times once it shuts off i will start it, it dies, start it then dies, and then start...
  3. T

    Immediate Shut Off Problems

    Good Morning all, I am currently troubleshooting a 2010 Evinrude Etec 90Hp for a co worker. I am told that the motor will start, idle, and 99% of the time run great. However, there has been a growing problem of the motor shutting down (Immediately with no progression downward, which makes me...
  4. T

    1997 Mercury 225 EFI coughing

    Good Evening, I recently bought a 97 225 EFI after it sat for 4 years. I cleaned my injectors this weekend and once all put back together it starts up just fine and at high rpm runs without issue. The injectors were pretty dirty and had large amounts gunk around the butterfly valves. Once...
  5. T

    1997 225 EFI has been sitting for 4 years

    I recently bought a 97 225 EFI that has sat for the last four years. It was properly stored and drained. The motor has less than 200 hours and supposedly rarely ever exceeded 30mph on a 21.5’ ranger. What all would you recommend I look/go through to make sure this motor hasn’t been damaged from...
  6. T

    Tilt Trim Issue/Mystery

    On my Johnson 50hp (J50PLEEA) I went in to change the top cap assembly on the tilt trim. While replacing the cap the pins, springs, and ball bearings of the pistons separated and had what I had thought were properly reassembled. After filling with fluid and no pressure build I open up the...
  7. T

    1998 Johnson 50HP

    When pressing trim or electric start relays click but no action. Blown solenoid?
  8. T

    2002 Johnson Bogging Down

    Anytime I accelerate motor bogs down. Ive cleaned the carbs and replaced the entire stator assembly. Starts and idles no problem Its a 2002 Johnson Enforcer 55HP two stroke Model #J55APRL Here is a video of what is going on... https://youtu.be/07plcmUHBV4 Thank you
  9. T

    2002 Johnson 55hp two stroke issues

    Motor is idling and starting fine but anytime i rev it it bogs down. Only thing I did in the time from it was running to this was run a compression test and unplug the power pack. Anybody know what this could be?
  10. T

    2002 Johnson 55hp two stroke issues

    Motor is idling and starting fine but anytime i rev it it bogs down. Only thing I did in the time from it was running to this was run a compression test and unplug the power pack. Anybody know what this could be?
  11. T

    1988 35 HP Two stroke review

    I’ve been offered a 88 35 hp on a trade and was curious what the overall opinion of this motor is. The seller says it runs great and has good compression. But would anyone have any advice to offer such as if this is historically a solid motor or if there is anything I need to keep and eye out...
  12. T

    55hp Issues with stator/spark lever

    So i have a J55APRL two stroke 55hp and have seem to have a domino effect of issues. After not getting spark I found that the primary coil had gotten severely damaged on the stator. On either end the thin stacked metal plates looked like a ham sandwich. Moving forward I replaced this part...
  13. T

    Air to fuel help

    Hey folks on my 2001 Johnson Enforcer 55hp I have rebuilt the carb but am having one heck of a time getting it dialed back in. It will only start and run at around 50% throttle anything below that results in it dying. I see there is the silver screw with the spring on it which I have fiddled...
  14. T

    2002 55hp two stroke starting advice

    Good evening folks, looking for for some advice my outboard runs fine when it’s on but at sometimes it’s a bear. Most times it starts on the first pull but then there’s times where you can pull it as much as you want but if there isn’t started fluid and drained carbs it won’t be starting. I got...
  15. T

    2002 Johnson 55HP Enforcer Electric Start

    Hey folks after searching the internet I am coming up short and wanted to seek help. I am looking to purchase an electric start for my 2002 Johnson Enforcer 55hp 2 stroke but cannot find any parts for it? Does anyone know where they could point me? I have searched deep
  16. T

    2002 Johnson 55HP Enforcer Rev Limiter Issue

    Hey folks, I recently purchased a 2002 Johnson Enforcer 55hp. The outboard has been converted to having a prop on it rather than the factory jet drive system. The engine runs like a top however once i hit about quarter throttle it begins to hit the rev limiter. Does anyone know why this could...
  17. T

    Water in oil

    Looking for help in diagnosing I have a 2006 Johnson 15 hp 4 stroke.... one day the impeller went out and the engine ran very hot for a short period of time. Weeks later the tube that goes into the intake started gushing out milky nastiness. I have reached out to some friends and they have...
Back
Top