Logo
FULL SITE MENU

Search results

  1. A

    1998 Evinrude 60 Water Pump Problems

    Replaced my entire water pump on my freshwater only 98 60hp evinrude, model E60TLECM and now in gear at high RPM the water through tell tale entirely stops pumping. First slows then turns to steam and then nothing. It will overheat but I kill the engine. In neutral I can give it as much throttle...
  2. A

    1991 25HP Johnson Tracker Outboard - Carb or Possibly sheered fly wheel key? Torque Specs?

    Hi everyone, I have a 25hp johnson (TJ25ELEID) and its been running fine up until a couple weeks ago. The motor while cruising along started sputtering and died almost like it was out of gas, fuel was low but enough that it shouldve kept running. I managed to start it up a few times after but...
  3. A

    Diagnosing low compression issue ('95 35hp johnson)

    Hi everyone, The motor hasn't ran for sometime and after cleaning it up it started fine the first time and has not started since(low compression now). The top cylinder 60psi, and 90psi in the bottom(checking it cold since it wont start now). I took off the bypass cover and looked at the rings...
  4. A

    1991 25hp Johnson Tracker: Power head replacements

    Hello everyone. I have a 1991 25hp Johnson. Model # TJ25ELEID. One of the head bolts snapped off and while drilling and using an EZ out(lesson learned), a piece of one of the bolt holes cracked off as you can see. I got it welded, and the weld didnt hold either. Im giving up on the power head...
  5. A

    Upper Water tube parts: 1991 Johnson 25hp, TJ25ELEID

    I just went to swap out the water pump on my outboard and the water tube came with it along with what looks like a very much disintegrating grommet of some sorts. I might try to just coat the end of the tube with gasket sealant and see if I can shove the tube back up and hopefully create a good...
  6. A

    1958 Evinrude Fisherman 5.5HP Leaking Gas from Carb

    My carb started leaking gas so I cleaned it and rebuilt it. New float, needle, gasket etc. It continues to leak from the gasket where the bodies meet and then it starts to leak out of the top right hole (view attached photo). I have taken the carb apart like 3 times and re-leveled the float...
Back
Top