Logo
FULL SITE MENU

Recent content by SR24

  1. S

    Wiring issues

    Thanks for the information.
  2. S

    Wiring issues

    It’s a 233 hp mercruiser with a pre alpha. The trim pump is a single solenoid
  3. S

    Wiring issues

    I’m looking for a little help with my 1977 Sea Ray 240 Weekender. I have changed the trim sender switches on the outdrive the limit switch was self explanatory . The position switch on the other hand is a little bit more challenging, the wires from the position switch go to this block below the...
  4. S

    11/4 in inlet hose

    Hello everyone. I’m looking for some information regarding the transom to thermostat hosing hose on my 1977 233hp mercruiser. What I have now is a 11/4 in diameter hose but I’m having trouble finding a model number for a replacement. On the back side of the inlet at the transom is a chunk of...
  5. S

    Sight bowl purpose

    Hello everyone, Can someone please help me I’m wondering if the glass sight bowl on the fuel pump is for water condensation or is it a gas filter. It’s on a 1977 351W. If it’s is for gas I would need to know what filter would fit it. It never had a filter in when I bought the boat. If someone...
  6. S

    Upper unit bearing race

    Hello everyone I am wondering if anyone has removed the bearing race in an upper unit of a mercruiser I have a slide hammer but the gap between the housing and the race has a gap that is to small for the arms to grab it properly.Maybe I’m using the wrong tool for the job. So if someone could...
  7. S

    Shift shaft leak

    Hello everyone .I’m looking for some help with with a problem that I have.I’m trying to pressure test my lower unit on my older MC alpha I keep having a leak around the shift shaft seal and can’t figure out how to stop it. I have changed it with a new one. If anyone can help me out it would be...
See more
Back
Top