Logo
FULL SITE MENU

Recent content by macdaver

  1. M

    power conversion I/O to O/B

    Good Morning, (or what ever time you r reading this). I had posted a while ago on trying to remove my AQ140, frozen shaft. I finally bought a hand grinder and cut through the u-joint. After tear down found that the knocking noise was not a rod bearing but burnt exhaust valve. Cylinders are...
  2. M

    Aq140/280

    Well back working on my Bayliner. I have yet been able to remove the drive shaft. Have helmet pushed up , the belows is off. The u-joints are a pile of rust, the trans is unbolted. There has to be something I'm missing. My last attempt I built a slide hammer using chain , 3/8 all thread a 2x6...
  3. M

    AQ140280 upper gear box

    Needing to rebuild my engine b Needing to rebuild my engine but I can not remove the upper gear box. I have gone as far as chaining it to a fir tree and won't budge.This is a 1979 Bayliner. Is there something I haven't done ??? I can see that the u-joints are pertty rusty but I can't believe...
  4. M

    280 upper end removal

    "Trying to remove upper end of "Trying to remove upper end of my 280 drive for engine removal. Have it loose but can't pull off the spline. Anyone have this problem? Thanks, Dave"
See more
Back
Top