Hello all, been doing a lot of reading and tried a bunch of things with no luck on coming off idle problem with my carb’ed 250.
Things I’ve tried;
-all fuel bowls rebuilt and carb plate idle orifices cleaned
-went from VRO to dual fuel pumps
-tried setting idle air settings from 4 turns to 10...
Can anyone tell me where I can find the barbs for the carb vacuum port/s? I am slowly ironing out all the wrinkles in this 2000 250 Johnson ocean pro. Found that 4 out of the 6 carbs needed rebuild and did all 6. Now I would like to build one of the vacuum port test sets to dial the carbs in but...
Short of the story is I purchased a 2000 250hp ocean pro. I run the motor on muffs and ran great, installed on boat and took it for a ride. Fired right off in water then it slowly idled down till it died. Then did the ole turn the choke knob up give it a pump on bulb and fired right up turned...
Short of the story is I purchased a 2000 250hp ocean pro. I run the motor on muffs and ran great, installed on boat and took it for a ride. Fired right off in water then it slowly idled down till it died. Then did the ole turn the choke knob up give it a pump on bulb and fired right up turned...