Does anyone know if the two coils in the gearcase are interchangeable? They have different
part numbers-forward(378549), reverse(378655). I want to make sure before I put together.
Thanks
I think you're right, after looking at new ones on Ebay it's worn out. I have one coming. I attached a pic of the carb roller. How does it look to you? I found a SELOC manual online and it doesn't mention lining up roller with the two arrows either. It did say after 1994 the 7 13/16"...
Adjusted the linkage on my '99 Johnson 40 hp according to the measurements in the service manual.
2 1/2" for the spark control rod(yellow arrows) and 1/2" for the idle speed screw(white arrows).
I found a OMC video on Youtube. See link https://www.youtube.com/watch?v=qigy9Ryha2A
It shows...
Replaced my VRO with a pre-mix fuel pump. VRO was bad and didn't want to mess with it.
Engine starts and runs good, but a chirping/squealing sound is coming from the throttle control. It's not loud
just annoying. Good stream from pee hole.
Appreciate any help.
Thanks
Working on a Johnson 40hp J40PLEEA. Was thinking about rebuilding the carbs and noticed they are different than the ones my manual shows. They are OMC 432439. My parts manual shows they should be OMC 439458. The major difference I see is mine doesn't have the carb cover (part #2) shown in...