Logo
FULL SITE MENU

Recent content by davidlyne

  1. D

    1989 200hp 2 stroke compreesion

    Hi all, I just had my 200hp 1989 2 stroke serviced and I wold like to know if these compression numbers are OK. 100, 100, 95, 90,95, 100. Thanks in advance. David
  2. D

    what do these numbers mean 200hp 2 stroke

    Hi all, just wondering what these numbers mean UL200AETO
  3. D

    Yamaha 200HP 2 stroke oil leak

    I have a 200hp 2 stroke Yamaha. After about a week with the motor in the down position there is a very small amount of 2 stroke oil running down the outside of the leg. There is no fuel in the oil, it is oil only. The leak is so small it doesn't drip on the ground. The oil injection system is...
  4. D

    1991 200 hp charging system

    I have a 1991 200hp Yamaha 2 stroke. I have 3 batteries in my boat with an isolating switch. Battery No 1 is single a marine battery. Battery No 2 is two marine batteries connected in parallel. My question is, will the outboard charging system be able to charge all three batteries at once with...
  5. D

    Yamaha 200HP 2 stroke alarm went off

    Hi, Was running my 200HP 2 stroke at around 4200rpm when the alarm went off. Immediately stopped the engine and checked oil level, both tanks were full. Digital tach gauge showed no problem. Water was coming out of the "pee" hole and engine did not appear to be over heated. 5 minutes later...
  6. D

    Spitfire electronic ignition 4.3 V6

    Hi, Hoping someone can help. I think my ignition system is playing up. Some times the boat runs fine then the next outing it blows lots of brown smoke and strong fumes hard to start and runs really rough and won't idle. Had carby rebuilt new leads new spark plugs. I remember I had a car many...
  7. D

    43l omc cobra engine missfires while cruisung

    "HI Guys, I hope someone can h "HI Guys, I hope someone can help with this one. I have a 1991 4.3l HO with 4bbl holley. 3 months afo the engine developed a miss at cruising speed about 23mph, 3,200 RPM approx. and got worse. I had the carby rebuilt professionally. All ran well until a couple of...
  8. D

    43l Cobra makes a clunk bang as if we hit something

    "Hi all, we have a 4.3l OMC wi "Hi all, we have a 4.3l OMC with Cobra drive. First off, thanks for your previous help. We went out on Saturday and after leaving the Marina, about 10 minutes at 6 knots, we accelerated up to 22 knots @ approx 3,400RPM. 5 minutes later there was a clunk / bang as...
  9. D

    Milky oil in outdrive

    "Hi, I am a very novice OMC ow "Hi, I am a very novice OMC owner, but I am fastidious about having things right. I checked the oil in my Cobra outdrive and it was full on the dipstick. I had a full service done on it by a marine mechanic late 2007 , and I assume the oil was changed then. My...
  10. D

    OMC 43L HO Hard to start when cold

    "Hi, I am new to this and woul "Hi, I am new to this and would like to ask the following questions. My OMC 4.3lHO is hard to start when cold, after being left for around 1 week. Runs and starts fine all other times. It is a carburetor model and has the spitfire electronic ignition. The...
See more
Back
Top