Logo
FULL SITE MENU

Recent content by Arty76

  1. A

    Timer base resistance readings

    Well, this is still driving me nuts, I bought a used CDI power pack and put on the original timer base and had spark to 4 of the 6 cylinders, I couldn't get spark on cylinders 5 & 6. The place I ordered the timer base from took 3 tries to get me one that looked like the one in the listing, and...
  2. A

    PL-88 load adapter

    If I disconnect the main wiring harness, and still have no spark, doesn't that eliminate the shift switch, the safety lanyard switch, and the key switch? Which would isolate the issue to the stator, the timer base, or the power pack?
  3. A

    PL-88 load adapter

    Thanks so much for responding, I've owned this boat since 2001 and have been dreading the time when this was going to start happening, I'm not very good with testing electronics, I've been reading through cdi troubleshooting, my stator is new, I think my timer base is ok, although when I test it...
  4. A

    PL-88 load adapter

    I have a 1995 Johnson 200hp Venom with no spark on all cylinders, the stator is new, the timer base dva output is .5 -.8 volts. To check power pack output my Seloc manual says to disconnect the primary lead to the coil and use a load adapter to check the voltage. Does leaving the primary lead...
  5. A

    Test wheel

    Thank you! I'll check that out
  6. A

    Test wheel

    Nobody out there has any info on test wheel part numbers??
  7. A

    Timer base resistance readings

    Right now I have no spark on all cylinders, I replaced the stator, I swapped the power pack with a new one I bought 2 years ago. I ordered a timer base.
  8. A

    Timer base resistance readings

    I don't have the optical ignition, but I assume the troubleshooting guide should cover mine?? Thank you.
  9. A

    Timer base resistance readings

    I have a 1995 Johnson 200hp. Venom. I've been checking the resistance on the connectors of my timer base following the instructions in my Seloc repair manuals (I have two of them), the best I can get is about 740 ohms from the white to the colored pins, from port side white to starboard side...
  10. A

    Proper procedure for testing timer base on OMC looper v6

    Why do so many questions go unanswered?
  11. A

    200 hp Evinrude 1997 - No Spark

    How did you test the timer base?
  12. A

    Test Prop Identification

    I'm still looking for a test wheel for a 1995 Johnson 200hp, any ideas??
  13. A

    Test wheel

    So now I'm looking for a test wheel/Prop for a 1995 Johnson 200hp.
  14. A

    Spark plug wires

    I did check out the website, they have several sizes available, thanks for the info.
  15. A

    Spark plug wires

    Thank you, but 4 inch is too short.
See more
Back
Top