Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
ELECTRICAL
ELECTRICAL
KEY SWITCH -4 POSITION
KEY SWITCHES
KEY SWITCH KIT
Four position keyswitch (Off, Accessory, Run and Start) Loose switch only. 7/8 in.
cut out
Can be used on DTS as well as non DTS installations
Three position keyswitch (Off, Run and Start) Includes keyswitch and mounting
hardware.
KEY SWITCH KIT - 4 POSITION W/MOUNTING
HARDWARE
2004 OptiMax 225 DTS outboards and 496 Mag MerCruiser DTS sterndrive and
inboard engines.
KEY SWITCH ASSEMBLY WITH CHOKE
Four position keyswitch (Off, Accessory, Run and Start) Includes keyswitch , key
cover, bezel, 2 1/8 in. Dia. mounting housing and mounting hardware. 7/8 in. cut
out
3 ft.(915 mm) harness without audio warning horn. Has 6 pin connector that adapts
Can be used on DTS as well as non DTS installations
to harness 84‑896537K_ 14 pin harness. 3/4 inch cut out with housing
KEY SWITCH KIT - 4 POSITION MATCHED KEYS-DUALS
Used with 2 cycle engines that require push to choke feature.
KEY SWITCH -3 POSITION WITH DECAL/WASHER
Four position keyswitch‑ dual engines (Off, Accessory, Run and Start) Includes
matched keyswitch , key cover, bezel, 2 1/8 in. Dia. mounting housing and
mounting hardware. 7/8 in. cut out.
Three position keyswitch with shorter key and mounting length (Off, Run and Start)
Dual engine ‑ matched key set. Can be used on DTS as well as non DTS
Loose switch only. 3/4 in. cut out. Includes switch with decal and washer.
installations
Can be used on DTS as well as Non DTS installations.
Three position keyswitch with shorter key and mounting length (Off, Run and Start)
Loose switch only. 3/4 in. cut out. Includes switch with decal and washer.
Matched set for dual engine installs
Can be used on DTS as well as Non DTS installations. Matched keyswitches for
dual installations
252