Logo
FULL SITE MENU

Search results

  1. D

    1972 evinrude 100 hp wonbt start

    i have a 1972 evinrude 100hp i have a 1972 evinrude 100hp turns over good but has no spark i was told to changee pulse packs but these $300.to $400.dollars is there anything i can check first . the fuse is good . it is getting fuel .is there a way to check the power pack or do you need...
  2. D

    72 evinrude 100hp wont start

    " i just got a 72 evinrude 100 " i just got a 72 evinrude 100hp (my first boat) the motor turns over good,good compression but no spark at the plugs any ideal where to start thanks dave "
  3. D

    95 johnson 225

    what is the max RPM on this m what is the max RPM on this motor. I have 24p ss prop and the boat will run about 6200 RPM. I do not wont blow it up.
  4. D

    SEA CAST POURABLE TRANSOM ANY GOOD

    HAS ANYONE USED THIS AT ALL A HAS ANYONE USED THIS AT ALL AND IS IT ANY GOOD
  5. D

    What is the best used 2cycle outboard motor in the 200hp range

    iam getting rid of my omc str iam getting rid of my omc stringers and converting to outboards never had one before and the bucks are to tight to go with a 4cycle. so i need a little help here thanks guys
  6. D

    1962 Merc 85 hp info

    I would to know how much tis I would to know how much tis motor is worth and are any of the parts interchangable with the 70s inline 6s I was told this is a rare motor. It is a 1962 inline 6 85 hp any info is great. P.S. whay is the fuel mix? Thanks every one for the help
  7. D

    55HP TROUBLES

    " MY ENGINE IS OVERHEATING, DI " MY ENGINE IS OVERHEATING, DID A COMPRESSION TEST AND TOP CLY.GET 10PSI MIDDLE CLY GETS 100PSI AND BOTTOM CLY GETS 100PSI GUESTION:WOULD THAT BE THE CAUSE OF OVERHEATING MODEL IS 55873R SER IS C577610 COULD TELL ME WHAT THE ENGINE IS TOO...
  8. D

    Carb always gummed up

    " I've got a 17' Invad " I've got a 17' Invader I/O with a mercarb carberator. I have to rebuild it at least once a season because the carb gets gummed up from the gas. I put an inline filter in there before the fuel pump (which has a filter also) so I can't figure out how it's getting gummed...
  9. D

    Alpha I outdrive wonbt break free

    " I have an 88 merc with Alhpa " I have an 88 merc with Alhpa I outdrive. I had been leaking salt water thru the gimble bearing/seal. I now can't get the upper housing off the boat. I get about 1/16" gap between the drive housing and the gimble housing and that is all. A mechanic said the...
  10. D

    for Jim Reeves

    How can I check ignition coil How can I check ignition coils on a 1962 Johnson 40 horse. Changed points and condensors. When first started both plugs had spark. Ran for about five minutes and now only one side has spark. Swapped plugs around and same side doesn't have spark.
  11. D

    Question for Joe Reeves

    " Joe, I have a 1962 Johnson " Joe, I have a 1962 Johnson 40 horse that the coils were taken off of. There are 3 holes on each coil and I have 6 screws, 4 short ones and 2 long ones(1-1/2"). Can you tell me where the longer ones go? Do they belong in the holes closet to the shaft? "
  12. D

    flywheel torque 40 hp johnson

    can anyone tell me the torque can anyone tell me the torque on the flywheel nut on a 40 hp johnson (1962)
  13. D

    Point gap

    could someone tell me the poi could someone tell me the point gap on a "62" johnson 40 h.p. also which coil goes to what cyl. one is green and one is yellow. I got this motor and it was already torn apart.
  14. D

    350 Distributor Question

    " I am in the process of putti " I am in the process of putting a Volvo penta I/O with a 350 engine together, I recieved the setup in pieces and got two distributors with the engine, one is the original mallory unit with points the other is a automotive HEI unit. The HEI is tempting because of...
  15. D

    1973 135 HP Evinrude Pistons

    " What is the differance betwe " What is the differance between a 1973 135 HP Evinrude from 1974 and up motors? I am having a hard time finding pistons for this motor and was told by a hesitent parts man that 1974 pistons "should work". When I tore the power head down it appeared to be just...
  16. D

    1981 Inline 6 115 Merc gas leak

    " I just got back from Tenness " I just got back from Tennessee on a fishing trip. I noticed gas on the water coming from my 1981 inline 6 115 merc. as I trolled all day. Pulled the boat out, took the cover off and noticed gas drops on the bottom of the top carb. What would cause the leak...
  17. D

    Looking for pump for a johnson 6hp motor

    im looking for a pump for a 6 im looking for a pump for a 6 hp johnson motor (3235960 Model number) the age of the motor is between 70 to 75 model i would like to get a price for the pump could some one please email me back to where i could pick one up from or they might know of a site where it...
  18. D

    Good Mechanic In Greater Cincy area NoKY

    " #F*?$&?ave my 1981 " #F*?$&?ave my 1981 Mercury 115hp inline 6 cyl. worked on for won't start, starter solenoid, won't get up and go, idles fine and runs fine up to about 2500 rpm, when you push the throttle forward it boggs down and will eventually die. If I pull back on it, it resumes to...
  19. D

    Mercery motor tote rod

    " I got a mercery 90 with my t " I got a mercery 90 with my tracker boat. Motors lower unit hang below trailor frame, Did they give me the wrong tote rod. Thank. DAVE "
  20. D

    71 Johnson Sea Horse Wonbt Start

    I am wondering where to start I am wondering where to start I just bought a 18' foot Larson with a 35hp Johnson outboard got it on the water and it won't turn over at all. Had a new battery and fresh fuel mix of 8oz oil to 6 gal gas. the electric choke is working but the engine won't turn over...
Back
Top