Logo
FULL SITE MENU

Search results

  1. A

    BF20D Surging

    When my friend said it had no fins left I wasn't expecting NO FINS.
  2. A

    BF20D Surging

    Found out why it wasn't pissing. Shop said it should be good now. He will test to see if it still surges this weekend.
  3. A

    BF20D Surging

    A question came up that regarding the possible over heating incident. The manual says when running in a tub that the water level should be kept 2" above the anti ventilation plate. I've always thought that the pump can't pull water so the level has to be at or above be the height of the pump...
  4. A

    BF20D Surging

    Impeller and pump housing are getting replaced tomorrow and he will launch it later this week. We'll see how it goes and report back.
  5. A

    BF20D Surging

    A friend has a BF20 approximately 2007. He took it out for the first time last week and he said it was "surging" and would not get his 16ft lund on plane. I know it ran perfect on the last run of last year. When he winterized it he probably ran it in too small of a tub and now it's not pissing...
  6. A

    Honda 5HP (BF5A) Leaking Oil When Tilted

    As NSDON suggested my older 7.5hp can only be transported or stored on one side.
  7. A

    BF20 (20hp) Choke Cable Install

    Hi there, I will be installing a new choke cable on a friend's 2006 BF20 (20hp) serial BAMJ-1302613. Part Number 17950-ZY1-003. It's ref number 20 in the attached diagram. I believe it attaches somehow to ref number 12 in the diagram. I don't have a service manual. Is it a straight forward...
  8. A

    Honda 1981 BF75 7.5 hp coupling - lower crank seal

    Thanks to hondadude I got my water pump parts ordered and hockeyguy helped me remove the extension case. I removed the extension case to replace the upper water tube seal. I noticed that where the upper part of the vertical shaft goes into the motor it's slightly oily. I'm wondering if I...
  9. A

    Honda 1981 BF75 7.5 hp pinion shaft

    Hi there. I'm trying to change my impeller. The impeller is stuck on the pinion shaft. When I tried to remove the impeller the pinion shaft moved up an inch or two. I don't want to create more work for myself. Will the pinion shaft pull all the way out? It would make getting the impeller...
  10. A

    Honda 1981 7.5 hp fuel leak from carb

    Hi there. I went to start my 7.5hp for the first time this year. I pumped the bulb till it was firm and it started 2cnd pull. Unfortunately fuel was pouring out of the carb somewhere. I shut it off and noticed when I pump the bulb, fuel comes out of the carb where I've circled it in red. I...
  11. A

    Honda BF75 -1981 leaky carb

    Hi there. I'm trying to diagnose a no start/poor start problem with my 1981 Honda BF75. When I pump the bulb I get fuel leaking out of the port circled in red. Is that normal? I did get it running for about 10 seconds. I did tear down the carb to clean it. But may not have done it properly. thanks
Back
Top