Logo
FULL SITE MENU

Search results

  1. T

    Pull Cord Replacement on 1982 4.5 hp Evinrude E5RHCNR

    Hello, Our pull cord broke for the last time the last piece came out yesterday. I know the recoiler has a large spring so I never wanted to pull it apart unless I had to. Is there a way that a new cord can be installed in place without pulling the assembly off? Otherwise it looks like it may...
  2. T

    Can I connect two 12 vdc Batteries in parallel to a 1984 90HP Evinrude

    Hi, When I use my fish finder with the main engine off and gas trolling motor the battery wears down over the course of the day. I was thinking of paralleling up another 12 vdc battery. Will the alternator be alright? Will the alternator charge both batteries with no issues or do I need to...
  3. T

    1984 Evinrude VRO 90 HP normal Cylinder T

    Hi, just ran my engine with muffs for 7 minutes the starboard side got up to 120 F and the port side got up to 100F at idle. Is that normal? The tell tale was flowing and the water was gtting warmer as the engine warmd up, water was also draining through the front(boatside)block just above the...
  4. T

    Evinrude 4.5 hp E5RHCTA Outboard tiller Handle Throotle Tension

    Hi, just wondering how I can adjust the throttle tension or friction on my 4.5 hp evinrude. The engine runs fine just seems to idle itself down once Imremove my hand from the tiller handle. Cannot seem to find any adjustment on the outside. Thanks in advance
  5. T

    1984 90 HP Evinrude E90TLCRD

    Replacing lower end gear oil and have just realized that I may be using the wrong gear oil. I had asked at the local boat dealer what to use and they recommended Quick Silver high performance gear oil. I used it last year and ran the engine 5 hours and about 1 hour the previous year and 3 hours...
  6. T

    1982 Evinrude 90HP storing for winter require proper engine position

    Hello, I am storing my 1982 Evinrude 90hp engine. I will remove the bottom gear oil and drop in some fuel treatment into the fuel tank. I will also remove the plugs and spray in the treatment spray and replace the plugs. Was wondering if the enigne should rest in the upright position on the...
  7. T

    Evinrude 4.5 hp E5RHCTA Outboard

    Would like to know where to grease the throttle plate on this engine. Cannot move the throttle plate by the throttle arm / lever without helping it along by hand. The engine runs find but cannot speed up or slowdown with throttle. Do I need to remove the flywheel in order to grease the throttle...
  8. T

    Throttle plate lubrication on 1983 4.5 hp evinrude

    Throttle cable is free but cannot move the throttle plate. Tried spreading grease on plate and under gear plate, can move throttle plate by hand but the throttle arm cannot move it. Engine runs fine just need to free up throotle plate. Have no manual. Engine has been out of service for 7 plus...
  9. T

    Does a 1982 Evinrude 90 hp engine have the same transom mounting pattern as a 1985 Evinrude 90hp?

    I have a 1982 16ft boat with a 1982 Evinrude 90 hp engine that has one blown cyclinder and I would like to replace it with another engine. I have f ound a 1985 Evinrude 90hp engine but want to make sure that I Do Not need to modify the transom on my boat. Do both engines have the same mounting...
Back
Top