Logo
FULL SITE MENU

Search results

  1. T

    2002 yamaha 2 stroke 115HP accelerating problems

    When I start the motor, it runs fine, but when I put it in gear, and attempt to accelerate, it wants to stall. If I push the choke in fast enough, it will accelerate and run great. Any suggestions? Could it be water in the carbs, or maybe air getting into gas line? Thanks Ray
  2. T

    PROP PITCH

    "OK fella's I'm gettin "OK fella's I'm getting closer to putting the 120hp motor in the 18ft Rinker. The 470 is out I will be picking up the alpha flywheel cover tomorrow to match it with the 1986 alpha. the old 120hp started right up on the stand and ran pretty good..The prop that I had on the...
  3. T

    Jump starting

    "When jump starting an inboard "When jump starting an inboard motor on a floor stand, where do you connect the alligator clips to?"
  4. T

    Inner transom problems with older 120

    "IM replacing the 470 in my 86 "IM replacing the 470 in my 86 rinker, and im down to the transom plate. The flywheel cover on the 1973 120 motor has a wider bole pattern,at the rear mount and will not bolt down to the 1986 rinker (alpha) transom plate. Will I be able to find a flywheel cover...
  5. T

    SWAPPING OUT a 470 for 120 MERCRUISER

    "Hi fella's I could still "Hi fella's I could still use som help with this swap. The boat is a 1986 rinker W/470. And I I got hold of an early 70's 120 hp still connected to the rotted transom. I also have everything thru the transom, up to but not including the outdrive. I need some...
  6. T

    Swapping out 470 for 120

    "could sure use smoe help moun "could sure use smoe help mounting transom plate, 1.the 120 hp transom plate does not line up. I'am trying to bolt it up to the existing gimbal housing which ia a 1986 rinker with an alpha drive. and its existing gimbal housing. the bolts coming thru transom...
  7. T

    Swapping out 470

    "After removing the 470 and th "After removing the 470 and the transom plate, I tried to install the transom plate to the 120 hp but the bolts didn't line up, I thought that it was supposed to be a standard pattern, Does this mean that I have to use the old gimbal housing from the 120? If so...
  8. T

    Removing a 470 from boat

    I'm stripping down a 470 a I'm stripping down a 470 as i'm pulling it out. Im down to the front mount and the bell housing bolts. My questions are #1- Do I have to pull the outdrive before unbolting the motor? #2 How many bolts will there be on the bell housing?
  9. T

    Swapping out a 470

    "I can pick up an 1981 cast ir "I can pick up an 1981 cast iron 4 cyl mercruiser, complete, including both sides of the transom. (everything but the out drive. Can anyone tell me if this is everything that I need. also someone told me that my 170 alpha drive may have the wrong gears, Can anyone...
Back
Top