Logo
FULL SITE MENU

Recent content by mokaction

  1. M

    Water in the oil in my F200TXRA

    I have water in my oil. The oi I have water in my oil. The oil is a chocolate milk color. The previous owner said that a gasket or seal is leaking under the power head. Question is dues this happen often? Also what would it take to fix it? To I need to pull the power head? If so what gaskets...
  2. M

    Are they the same hole patterns for mounting motor

    "I have a Johnson 225 87, and "I have a Johnson 225 87, and just purchased a Yamaha f200. Are the mounting hole pattens the same? Or do I have to drill out new holes for the Yamaha?? Larry"
  3. M

    Hard Starting 225 Johnson 87 after it warms up

    "Wonder if anyone else has had "Wonder if anyone else has had this problem. My 87 Johnson 225 would start up cold with no issues. Once I have found a fishing spot, and would stay there for 30 mins are more. Then engine wouldn't start property. I would prime the motor and it sounded like it was...
  4. M

    After Running my 225 Johnson idles poorly at the end of the day

    "Question, Full rebuilt 87 "Question, Full rebuilt 87 Johnson 225, When I start it up in the morning it runs great. All day. Then when coming home I run it for about 26 miles or so keeping it at around 3.5k to 4k rpms. Once in the harbor my motor seems like it will not idle as well as...
  5. M

    4 stroke 99 1988 changing water pump

    How do you un hook the shifter How do you un hook the shifter rod?? Larry
  6. M

    Only at start up my motor Sneezes

    I have a J225TXCUB 1987. Just I have a J225TXCUB 1987. Just rebuilt every thing even the carbs. Motor only sneezes when you start it in idle. Once it warms up it stops. What is causing this? Also if I have to rejet the idle. Then where do I get the new jets??
  7. M

    How Do you Remove Pinion Bearing Shimming up the drive shaft j225txcub87

    "I just recently took apart my "I just recently took apart my lower end and would like to replace the pinion to drive shaft bearing. Is there a way to removed it out the prop hole? or is it put up out of the drive shaft? Also do I need any special tools? Or can I just rig something up?? Turn...
  8. M

    Getting Clogged Fuel Filter How do you clean out Gas Tank

    I would run my boat for about I would run my boat for about a hour and the fuel filter would clog out and stall out my motor. How do you clean out in boat gas tank? Larry
  9. M

    What is the Best way to clean this corrosion

    "I have never had a block this "I have never had a block this corroded? How would you clean this off? Larry"
  10. M

    Broken Rings in Cyl

    "engine is J225TXCUB.. Well "engine is J225TXCUB.. Well for all you that have been following my threads, I have been having major problems with my engine. Tried to take it out X-mas eve, and engine would not idle. I have replaced all the ignitions and tested weeks ago and all is...
  11. M

    Thanks To all and special thanks to Joe R and Justintime

    "Just letting you guys know th "Just letting you guys know that I did some sea trials today. And boat ran sweet. Looks like it was the timing base, stator, and powerpacks. Also running with out the interrupt switch, and getting in and out of gear sweet. Just letting you guys know I also rebuild...
  12. M

    Spark Plug Wires J225 87

    "Well did a ohm test to the co "Well did a ohm test to the coils and spark plug wires. All coils ohm to spec, but as for the spark plug wires. I get 5 wires with 520 ohms. And 1 with 980 ohms? Dues this really matter with spark plug wires? Also if you can explain why? I would like to...
  13. M

    Discolored plug out of 6 plugs J225hp 87

    "Thanks in advance for the adv "Thanks in advance for the advice. I was checking out my plugs today, and notice that one of them was discolored compared to the others which all looked normal? Also check compressions and they were all 95psi for a looper. What can cause this discolored...
  14. M

    Joe R Question aboutShift interrupt switch

    "Joe, Is it OK to just by p "Joe, Is it OK to just by pass the Shift interrupt switch?? And hook up the yellow and black wires on both powerpacks? Or do I still need the isolation diode that the switch provides to separate the two power packs?? The motor shifts smooth in and out of gear...
  15. M

    New Problems with my J225hp 87

    "Yesterday motor ran like silk "Yesterday motor ran like silk. Now there is a new problem. When out diving today and engine started messing up again. It would start then would blow back in the carbs then stall. I would have to keep starting it then it keeped stalling Once I got it...
See more
Back
Top