Logo
FULL SITE MENU

Re-assemble Alpha One lower unit...

I

Iowa Mike

New member
I've got a 1987 Rinker with the 5.0 200 hp chevy V8 and the Mercruiser Alpha One Gen 1 sterndrive. I changed the water pump, impeller, etc and tried to put the stern drive's lower half back on but something's stopping it from going all the way up. It seems like the drive shaft's splines aren't messing up inside. I pull it down a bit and turn the prop just a hair but still no go. I tried this at least 10 times now and I took a break. I can see that the studs are up through their guide holes to where I can see the tops of them. The shifter shaft isn't hanging up either but something's definitely hitting somewhere cause i can feel it. I greased up the driveshaft at the splines and I can see it's hitting but not going in. So, what am I doing wrong or what's the trick to get it all the way on?
 
Drive is in forward, right? So the prop is locked in the counter clockwise direction, and throttle is in full forward position

If all true, recheck the water tube
 
Yes the shifter is all the way forward and the prop is locked when I try to turn it counterclockwise. I'll re-check that water tube in the morning, thanks!
 
with the control box in full fwd, the lower splined shaft turned fully CLOCKWISE for fwd gear.then lower the upper unit while turning the brass shoe clockwise and stopping when at a straight line.upper should drop down. Now the tricky part, slightly raise the upper start the 2 side nuts and snug them down. With the prop shaft locked counterclockwise the brass shift show should be facing in the 12:00 position exactly
 
Back
Top