Engine ground cable for BF225 part no

[b225]

What is part no for Engine ground cable? Is it part of some harness cable set? Need is to renew just main ground cable fro below engine:

BF225A 2003
BAGJ-100342x

 

[b225]

Also where to find documents showing exact locations of Main Grounding Points on the Honda BF225 Outboard:
1. Main Engine Block Ground (near the starter motor)
2. ECU Ground Point on the Engine Frame
3. Ground Junction in the Wiring Harness
4. Dashboard Ground

 

[b225]

Also what is part no for CKP sensor for
BF225A 2003
BAGJ-100342x

Is it as my consultant says:

Correct CKP Sensor Part Number:​

30300‑ZY3‑013​

Curious also of steps to replace it as my consultant says:

Why this job is doable for a DIY person​

• The CKP sensor is held by two small bolts
• The connector is a simple plug‑and‑click
• No timing adjustments or calibration needed
• No fluids to drain
• No special Honda tools required

It’s basically:

1. Access the sensor
2. Unplug it
3. Remove two bolts
4. Install the new one
5. Plug it back in

That’s it.

 

[b225]

I assume page 2-33 of Honda-Outboard-service-workshop-and-repair-BF175A-BF200A-BF2 is best available for ckp location?

 

[b225]

Also where to find documents showing exact locations of Main Grounding Points on the Honda BF225 Outboard:
1. Main Engine Block Ground (near the starter motor)
2. ECU Ground Point on the Engine Frame
3. Ground Junction in the Wiring Harness
4. Dashboard Ground

That must be no 1