Ditto Chris re; warming the engine up and doing a fresh Comp Test when she cools back down!
Bill makes a good point regarding water being in the Stbd bank (#2 thru #8) and this causing the high readings... .... but why so evenly???
Did you by chance squirt a large quantity of oil in these cylinders prior to the comp test????
guys i recently did a compression test ..............
here are results of dry test.
1.... #1-150 #3-120 #5-159 #7-165.
2.... #2-205 #4-185 #6-198 #8-198.
3.... this is a 350 ,.030 flat tops,
4.... it seems to me that the #1 thru #7 is strange.
5..... are these readings acceptable?
6... i will be pulling the heads off and having them checked
OK, I'm suggesting the following due to the difference that I'm reading between the Port and Stdb sides.
1.... This would be the Port side...... #'s 5 and 7 are acceptible..... #1 is low, #3 @ 120 is very low. Something is wrong here.
2.... This would be the Stbd side...... these readings are high, but are likely acceptible with regard to the % of differential, but again something is wrong with these higher readings.
3.... For the Marine SBC 5.7L, Flat Top pistons are suitable with 76cc chamber cylinder heads..... not 64cc chambers!
4.... Yes, it is strange to me also!
With #3 above in mind, I'm going to suggest that the Stbd cylinder head may be a 64cc chamber casting, and that the Port cylinder head is a 76cc chamber casting....... or somewhere in the neighborhood of those.
5.... No, not with the % of differential, IMO.
6..... I'd pull the valve covers and look at the casting numbers. I'd then go to
http://www.nastyz28.com/sbchevy/sbch.php or this web site
http://www.auto-ware.com/techref/castnum.htm and see if your casting number is listed.
The chamber volume should be listed in one of these web sites. There are many cylinder head combustion chamber volumes for the SBC.
I don't know how anyone could mis-match these....., but never say never.
The Flat Top piston is a great choice for a Marine SBC. With the correct deck height and head gasket, you can give this a good quench area.... very important for Marine use, IMO.
However, this piston should be accompanied with the 76cc chamber head to keep the C/R correct... ( unless this is for a small Hot Rod boat )
.