I bought a blue wave with a 2017 engine installed on boat in 2019. The motors only has like 40 plus hours.
1. Ran at idle as it should.
2. Launched boat and in limp mode
3. Removed VST and all filter were nasty just from bad gas
4. Replaced high pressure fuel pump with OEM pump
5 replaced all filters
6. Purged all fuel lines and new water separater on main line
7. Filter by low pressure pumped changed
8. Checked head and block thermostats and were in good shape and functioned properly but the head thermostat was in the block and vise versa. Now in right spot.
No visible corrosion in block or head thermostat holes
Now hers my issue: when the motor is running the lights by the key are 4. One red , one below it red then Green and another red.
That bottom red light stays on as well as the green as it should.
The symbol for that bottom light is missing. Is that for overheating.
I’m attaching a picture with just the key turned on and not running of the light. HELP
1. Ran at idle as it should.
2. Launched boat and in limp mode
3. Removed VST and all filter were nasty just from bad gas
4. Replaced high pressure fuel pump with OEM pump
5 replaced all filters
6. Purged all fuel lines and new water separater on main line
7. Filter by low pressure pumped changed
8. Checked head and block thermostats and were in good shape and functioned properly but the head thermostat was in the block and vise versa. Now in right spot.
No visible corrosion in block or head thermostat holes
Now hers my issue: when the motor is running the lights by the key are 4. One red , one below it red then Green and another red.
That bottom red light stays on as well as the green as it should.
The symbol for that bottom light is missing. Is that for overheating.
I’m attaching a picture with just the key turned on and not running of the light. HELP

