I have an 04 BF 200 that had the fuel system replaced 3 years ago due to loss of power that turned out to be corrosion in the high pressure fuel pump. (used ethanol gas) since then its run at least once a month and with only good gas (non ethanol 93 octane) I drained the gas out of the tank as it was in there for some time and had it set up to run on gas can. my son took it out and decided to fill the main tank 80 gal ran half of it out running good. Took it out two weeks later. Loading CC he disconnected a ground for the gauges (didn't know this at the time) filled back up but took it out with out gauges. Ran great at the end of the day it wouldn't plane or go up above 2k, no lights beeping nothing. After getting it back I find the wire disconnected gauges work and was almost empty. Hoped he just ran it to low hooked up can again no power, replaced low pressure filter (some dirt) high pressure and vast are clean still no power. Plugs look good compression is good fuel bulb is firm nothing happens when pumped. IAB was a little sticky.