Current visitors

chawk_man

Silver Medal Contributor From Hague, Virginia, USA

Joined: Sep 16, 2008

Last seen: Yesterday at 5:47 PM

Latest activity Postings About

- C
  
  chawk_man replied to the thread Honda BF225A No Start Journey.
  
  Perhaps the attached diagram will help. It's for dual engines, but easy to figure out for a single engine. From the diagram, Green (G)...
  
  Sep 20, 2023
- C
  
  chawk_man replied to the thread BF175 cooling issue.
  
  Glad you got it fixed. Good work.
  
  Sep 13, 2023
- C
  
  chawk_man replied to the thread bf200.
  
  WOW, this is a real head scratcher. Have you tried measuring the pulse signal at the coil connection? You will likely need a very good...
  
  Sep 10, 2023
- C
  
  chawk_man replied to the thread bf200.
  
  1. Did you also test the coils to #4 and #5? 2. If not coils, plugs, injectors, and not the ECU, then it is almost certain that the...
  
  Sep 10, 2023
- C
  
  chawk_man replied to the thread Water temperature gauge or water pressure gauge?.
  
  I have little experience with 2-strokes, so I will defer to Makomark on that issue. However, I do know these big 4-stroke Honda’s quite...
  
  Sep 7, 2023
- C
  
  chawk_man replied to the thread bf200.
  
  You are using NGK IZFR6F11 iridium-tipped plugs, correct?
  
  Sep 6, 2023
- C
  
  chawk_man replied to the thread bf200.
  
  More detail would be helpful. How do you know those plugs are not firing? Very unusual for two plugs to fail simultaneously. Are you...
  
  Sep 6, 2023
- C
  
  chawk_man replied to the thread Water temperature gauge or water pressure gauge?.
  
  I agree with adding temperature gauge. Typically, if a marine engine detects an overheat situation, it will shut down and will not...
  
  Sep 6, 2023
- C
  
  chawk_man replied to the thread BF225 rough running.
  
  Yes, plausible, IMO. The heater element is supposed to get the sensor up to around 600 degrees F. If you pull fault codes, a failed...
  
  Sep 5, 2023
- C
  
  chawk_man replied to the thread BF200 Leaking fuel from vapor separator.
  
  Ditto
  
  Sep 5, 2023
- C
  
  chawk_man replied to the thread BF225 rough running.
  
  I've never experienced that when the IAB kicks in. However, occasionally, I do get a minor surging (~100 rpm) between 4200 and 4600 rpm...
  
  Sep 5, 2023
- C
  
  chawk_man replied to the thread BF200 Leaking fuel from vapor separator.
  
  jgmo - Nice, detailed analysis. Thanks for jumping in and clarifying.
  
  Sep 5, 2023
- C
  
  chawk_man replied to the thread BF225 rough running.
  
  Glad you found the problem. Recall that the IAB is activated at 3950 RPM, so check to make sure that the diaphragm is working and grab...
  
  Sep 5, 2023
- C
  
  chawk_man replied to the thread BF225 HO2 Sensor Failure Error.
  
  Here is what I stored from previous posts: Try this thread...
  
  Sep 5, 2023
- C
  
  chawk_man replied to the thread Honda 130 midsection whirring.
  
  In older Hondas, these mid-shaft bearings were notorious for failing and in some cases even eating a hole in the front of the mid-shaft...
  
  Sep 5, 2023
Show older items
Loading…
Loading…

Home
Members

Outboard Motor Parts

Inboard & Sterndrive Engine Parts

Manufacturer Catalogs

All Engine Brands

Outboard Repair Manuals

Inboard & Sterndrive Engine Manuals

Shop by Accessory Category

Please Note

Join the Forum

Discussion Topics

Outboard Motors

Inboard & Sterndrive Engines

Contact & About

Ordering

Returns

chawk_man

Latest activity Postings About