Thomas1410
New member
Recently pick up a small 15 fiberglass bass boat and it had a evinrude 30hp on back hours unknown only 2 owners and was garage well kept. When I received the boat the man let it sit for 2 years in shop no cranking. I started by a general service new prop, plugs, wires, foot oil and impeller. Also bought new throttle cables and steering cables. The work was all done by a mechanic here in my town, since it needed new cables. Took it out and it would die with throttle. Returned to mechanic they replaced the choke system with the red lever checked compression and rebuilt carb. Took it out again would run but then after fishing with motor lifted it will not crank and run. Returned yet again they replaced all fuel lines found fuel lines were wrongly placed and rechecked carb and replaced chock system yet again. They then told me they ran the boat at the lake and was good to go. Same thing happened again after fishing in a spot for about 2 hours motor would not crank. Mechanic told me he had never seen anything like it and said next step was head gasket. Has this happened to anyone? Anything I could be doing wrong? I’m stumped on it too, only thing I can think of maybe the metal gas tank built into boat or maybe air locking?

