Logo
FULL SITE MENU

1984 E70TLCRD Driveshaft shimming

S

stephen k

New member
Hello Everyone, I have a part number dilemma. The driveshaft broke in the 70 hp Evinrude and I have it all apart cleaned and new shaft on the way. I have read everything I can find online about the shimming process but for the life of me I can't find the part number for which shim gauge bar to buy for checking. There are so many with every dimension known to man. Can anyone point me in the right direction?

Thank You all.
Evinrude
1984 E70TLCRD
70 HP 20 inch.
 
faztbullet said:
You need the shimming tool not just the bar... just take it to a dealer and pay them to do it.
Click to expand...
Yes Sir, I understand that. I have other means to set up the shaft to measure, I just cant find the spec for my motor. If I new which bar to use, or the measurement specified on the correct bar, I could do the math.

Thanks Again. Steve
 
Math don't preload the bearings thus the reason for the tool, collar(328363)and bar(328366)(7.511) your gears and good luck.:(
 
Back
Top