Logo
FULL SITE MENU

Search results

  1. J

    Mercruiser Gen 2 upper driveshaft seal

    I'm resealing the upper on a gen 2. The seal that came out of the upper drive shaft housing was a single double lipped seal. My question is can you use back to back seals instead? My seal kit came with both types.
  2. J

    2003 Johnson 150 OIS gear reduction starter

    Starter started running slow so I bought a new aftermarket starter that wont engage the bendix. When I was checking it I noticed it was turning counterclockwise. If I'm not mistaken doesn't it need to run clockwise. It bolts up fine and turns strong just wont engage the bendix. I can manually...
  3. J

    1999 90 HP ficht loss of top end speed

    From every thing I have read it looks like my throttle position sensor is bad. Ohm check between the gray and green wires shows an open circuit at about 1/4 throttle then picks back up. The guage did not flash any codes with TPS hooked up, however when I removed it and put it at WOT it flashes a...
  4. J

    2000 Johnson 115 carb needle & seat question

    I'm installing new kits and I noticed the old brass needle & seat did not have the nylon gasket on the seat when i removed it. When I installed the new seat w/gasket the float stuck up so much that I would have to bend it a lot to make it level. My question is do you use the gasket on the seat...
Back
Top