Logo
FULL SITE MENU

Search results

  1. R

    tilt/trim motor

    I have a 94 evinrude 112spl. the tilt/trim stopped working. relays click when I push button up or down. I have 12v going into relays and 12v coming out. also have 12v on both sides of where motor plugs into wire from relay box. I used a jumper and put 12v to motor and no up or down. replaced...
  2. R

    evinrude carbs

    when i was rebuilding ones i have the intermiate jets broke off and there not set all the way down. the top of jet is even with top of float bowl. it has the plastic bowls the ones im looking at have been upgraded to aluminum bowls
  3. R

    evinrude carbs

    i have a 94 evinrude 112 spl(tslers). ive found a goid deal on a set of rebuilt carbs but they are off a 96 112. my quesrion is will they work on my motor? the rebuild kits are the same for both but i know they can cover multiple years. thanks
  4. R

    94 evinrude v4

    thanks racerone. the compression is 120-126 in all 4 cylinders
  5. R

    94 evinrude v4

    i just got a 94 evinrude v4 112spl. it had been sitting for a few years in a basement with fluids drained. i went over everything. have water pump and carb kits ordered. but ladt night i started it and it runs good except that as soon as i start it i get a constant loud beep from the remote box...
  6. R

    thermostat help

    i got a 89 evinrude 60(te60tlcea). when i got it it was in rough shape but comprrsdion is 123, 120, 124 in it. when going over motor the thermostat housing was empty except for large spring. so i got thermostat and put it in and ran it in a tank and it seemed new tstat was stuck closed, got...
  7. R

    lower unit compatability

    Does anyone know if a 1995 2 cylinder 50hp Evinrude lower unit will fit a 1989 3 cylinder 60 hp Evinrude?
  8. R

    lower unit compatability

    Quick question. Is a 1995 2 cylinder 50 hp Evinrude compatable with a 60 hp 3 cylinder Evinrude tracker 1989. The 60 has the big foot lower unit on it but was wandering if I could put the 50 lower unit on it
  9. R

    fuel pump?

    I just got a 89 Evinrude te60tlcea. I took all 33 carbs off and soaked, cleaned with carb cleaner and blown out with air. Compression is between 120-125 in all 3 cylinders. Took it out 1st time last weekend. It starts and idles well also runs higher speeds well except that after a minute or so...
  10. R

    fuel pump?

    .....
  11. R

    torque specs?

    I ordered service manual but won't be here till wed. I need torque specs on. Cylinder head. I just did head gasket I have the bolt pattern but don't know what to torque them to
  12. R

    50 hp Evinrude help

    I have a 1995 Evinrude 50(e50tleod). It won't idle unless I give it a little throttle and it tops out at 9 mph, I usually get about 30 mph, at wot. I've changed fuel filter. I checked replaced spark plugs and tested the spark is blue and jumps 1/2" on tester. I've never run ethanol gas in the 3...
  13. R

    no spark on 60hp mariner

    These sre ignition couls like are in motor and thank all for the replys and help
  14. R

    no spark on 60hp mariner

    These are the switchbox i ordered from part numbers off existing parts
  15. R

    no spark on 60hp mariner

    I got a 60 hp mariner serial 0g185851(1995). It hadnt been started in at least 3 years. I put new impeller on it and new plugs. Cleaned it up and it started fairly easy. Only ran it about a min cause it was raining. The next morning before i went to laje i started it again and it ran about 3...
  16. R

    60hp mariner issues

    Hi. New to the forum from va. I recently found a mariner 60hp on craigslist. The guy i got it from said he was told it worked 3 years ago when he got it. I got it for free. I hooked it up on motor stand at back of my boat and hooked it up, new spark plugs and it fired up and ran but no water at...
Back
Top