Just installed a set on one engine and ordered a second set for the others.
I found them on line from an outfit in NJ.
Price was less than half than the set of Mercruiser original branded Kit.
Side by side, the casting looks identical to Mercruiser. (Except for the name)
Manifold number 5735...
2006 Sea Ray
Twin 350 Mag MPI
Dry Fit System, Warm Risers
This is not intended to be a debate on whether or not I should buy a new exhaust system
I removed the exhaust on one engine to check their condition.
After 5-1/2 seasons they are in great shape.
Even in the tail end ( At the...
I saw this on a sea ray fourm where i'm a member.
The left is a newer style sea water pump cover with an integral stainless wear plate.
I have found the following part numbers: (in a much later engine than mine)
Cover w/out air fittings 862776A01 (This is the same number as mine)
Wear Plate...
My new pressure gauge.
I found a 1/2 -13 brass stud 3" long. Drilled the center out about 1/8". Installed 1/2" nylon lock washer.
0-30 psi gauge with 1/4" pipe fitting, coupler, 4" nipple.
The two connected together with 1/2" id hose and clamps.
This should screw into anyplace there is a blue...
Why does one side have the small hole?
I have a riser block so do I get 2 restricter gaskets?
This system is new to me.
I understand the pourpose for the improvements.
Are they supposed to last longer or are they just safer?
Thanks!
Mercruiser 350 MAG MPI* Bravo 3 , Gen3 Cool Fuel, Raw Water Cooled, 3 point drain
I am in the process of tracking down a over heating issue on my Starboard engine.
I have replaced the impeller and thermostat
I have the smart craft (System view) which show water pressure on both engines side by...