Logo
FULL SITE MENU

Recent content by voyagerv20

  1. V

    43 Mercruiser oil change

    "My last I/O Mercruiser 3.0 ha "My last I/O Mercruiser 3.0 had a hose on the bottom of the oil pan that i could pull threw the rear drain hole to drain the oil, I recently purchased a 1999 4.3 Mercruiser, at the bottom of the oil pan drain is where the dipstick tube is attached. When usng one...
  2. V

    97 90hp Force wonbt Idle

    "After first starting it will "After first starting it will idle ok, but after runing for about a minute it dies, if you can get it gear and throttled up befre it dies it runs good on the go. And when it dies its hard to get started again. Have rebuilt carbs and fuel pump. It need all of this...
  3. V

    1997 90hp Force Carbs

    Hi I have a 1997 90hp Force Hi I have a 1997 90hp Force I need new needle and seat I ordered carb kit 18-7033 everything fits except the needle and seat. Looks like my seat is not removeable and the new needle does not fit in this seat. What needle do i need and where can i get it?
  4. V

    Prop Size

    I have a 1997 90hp Force on a I have a 1997 90hp Force on a 20' Pontoon at wot it has about 5500 rpm at 21mph I wanted to lower the rpm a little and get a few more mph. The prop on it (original) is stamped with 13p so I replaced it with a 15p. My rpm went up to like 5800 and mph went down to...
  5. V

    1997 Force 90hp Decal

    Where can I find The Hood Deca Where can I find The Hood Decals for a 1997 90hp Force Engine? Even if after market. Don't want to spend a lot. Don't even have to Exact.
  6. V

    1997 90hp Force

    I have a 1997 Force 90hp On a I have a 1997 Force 90hp On a 1997 Voyager 20' pontoon. My question is when I push it to wide open throtle it cuts out a little if I run it this way for a minute or two it dies. Then its alittle hard to start but will start. It runs great at half throtle. Let me...
  7. V

    Outboards and cold water

    I was wondering how cold of la I was wondering how cold of lake water is to cold to run an outboard motor in? The tempreture around here has been between 15 f to 37f this coming weekend suppose to get to 50 would like to take the boat out for a test run.
  8. V

    1997 90hp Force

    Hi I have just purchased a p Hi I have just purchased a pontoon Boat with a 1997 90hp Force. On the back side of the lower unit there is a 90 degree fiting screwed in with a short plastic tube conected to it. (about 6 inches long) It looks like it is pluged with some kind of plug. What is...
See more
Back
Top