Logo
FULL SITE MENU

Recent content by RUNER

  1. R

    Tohatsu MFS60 Tilt & trim setting question

    👍
  2. R

    Tohatsu MFS60 Tilt & trim setting question

    Thanks. The thinking here would be that I can limit the amount of current going through the switch and hence limit the up/down trim? Thanks
  3. R

    Tohatsu MFS60 Tilt & trim setting question

    Hi Paul, any links that you could direct me to. Thanks
  4. R

    Tohatsu MFS60 Tilt & trim setting question

    Hi All, I have a question wrt setting the tilt and trim level of the outboard either via the remote control or from the button on the engine. Is there any way i can set the tilt that when I trim the engine on the go that it does not raise beyond a certain level? I have seen you tube videos of...
  5. R

    Tohatsu MFS 60 WOT

    Thank you sir
  6. R

    Tohatsu MFS 60 WOT

    Got in touch with the dealer and he came clean stating this was the first time he paired the MFS60 with a boat similar to mine. As you can see from the picture it’s a V hull but not that deep. Its claimed weight is about 1000 ILBS and it can take a max of 60 hp. A same/SIMILLAR setup has been...
  7. R

    Tohatsu MFS 60 WOT

    Thanks Paul, I tried shifting the wife and kids and got out of the hole very slowly and the rpms climbed once on plane. I ll reach out to the dealer to see if I can get a better sized /pitched prop
  8. R

    Tohatsu MFS 60 WOT

    Hi All, New to the forum and Tohatsu outboards. I just switched over from a Yamaha Centre console to a Tohatsu Tender powered by a brand new Tohatsu MFS 60. The boat was idled and driven on low rpms per the manual. The boat has a max of 1hr of use and I could not get it above 4000 rpm at WOT to...
See more
Back
Top