Logo
FULL SITE MENU

Recent content by jodobbs70

  1. J

    2006 bf 225 basically in a bolt tub

    Awsome. Thanks. Test confirmed the Amazon map sensor to be garbage. Test also confirm 5v on reference side but 2.76-2.96 on signal side. Question is, doesthat mean my ecu is done. ? The way the procedure is written has me confused. Mine is reading 3.1 volts. Is there a procedure for testing my...
  2. J

    2006 bf 225 basically in a bolt tub

    Ok. So I took it to my shop here to be scanned. It seems likely the map sensor is pooched. Can’t really confirm this without the break out box/harness thingy. My mechanic says he can ohm all the systems and ecu but it will take hours. He suggested ordering a map sensor from Amazon cause they...
  3. J

    2006 bf 225 basically in a bolt tub

    I here ya chaulk man. And appreciate your experience. Tore the vst down yesterday, spotless. Plastic case spotless. On my 06 I know the water in fuel is single tone one second as I confirmed by activating float in the key/run position. After the bad fuel I drained both internal and ray or...
  4. J

    2006 bf 225 basically in a bolt tub

    Again 190 psi an all 6
  5. J

    2006 bf 225 basically in a bolt tub

    No it’s a one second on one second off. But when I flip the seperAtor upside down it gives the same alarm with the key in the run position. Then flip right way up and alarm stops. So I know it’s functioning. I did get a bad batch of fuel and then these issues started. Replaced all filters...
  6. J

    2006 bf 225 basically in a bolt tub

    I have only the red and green light. Oil and heat. I’ve checked the seperAtor and it’s good. I confirmed by flipping it over with key in the run position and it gives the alarm. Same alarm as it gives me when I start motor. So it’s not water. All filters are new. I’ve ordered the hp pump...
  7. J

    2006 bf 225 basically in a bolt tub

    I rescently got a 2006 bf 225. It’s on a 206 podded double eagle It’s surging at idle from 500 to 1000 rpm. It goes into a 1 second on /of alarm within 10 seconds of running. I got fed up and planted it. Alarm went away Another issue is when it stops screaming at me in the one second bleep...
  8. J

    1988 mariner 150 magnum tilt issue

    Hey guys. Head zcratcher for ya. I put a new tilt trim mptor and pump assembly on 6 years ago and hung the motor on a stand. Goin to mount it now finally and the trim motor is working but i have now tilt up or down. Theres plenty of fluid . Is there something im missing or has the pump dreid up...
  9. J

    290 tilt

    Hey folks, I do alot of fiberglass ztuff here on the west coast of canada, vancouver island to be exact. Basically rebuilding any double eagle or hourston glascraft. They are staples here on the west coast. Generally find garbage ones and full gut job. New stringrs , transoms , floors.. Ive...
  10. J

    2003 temp gauge sending unit

    After years of a 200 black max she finally ate herself. I had a 2003 90 hp sittin in the shed so threw it on. My question is i cant find the tan wire to hook up my temp gauge. All i have is a black and yellow and black wire that im guesing sounds the alarm in the controls. Im a gauge guy and...
See more
Back
Top