Logo
I
Reaction score
0

Latest activity Postings About

    • I
      iang6766 replied to the thread 2009 Honda BF200 oil weep hole?.
      The rear main seal plate is hard to tell from the photo.
    • I
      iang6766 replied to the thread 2009 Honda BF200 oil weep hole?.
      Item 19, it's the seal for the plate that covers the top eng mounts, the plates tend to cortode over time, pull it off, check it and fit...
      • Screenshot_20240228_053139_Samsung Internet.jpg
    • I
      iang6766 replied to the thread Salt away.
      Wierd one
    • I
      iang6766 replied to the thread Salt Away.
      Impossible for salt away to do that. Must be insufficient water supply causing engine overheat and gaurdian. Check your attachments make...
    • I
      Just a short conment to add to Jimmy's wealth of knowledge on these little motors. The lightest steel fishing trace is an excellent jet...
    • I
      iang6766 replied to the thread 2009 Honda BF200 oil weep hole?.
      Do the block anodes and upper engine mount cover plate seal.
    • I
      Just leave it alone and use an oil extractor through the dipstick tube, you will get all the oil out
    • I
      iang6766 replied to the thread Honda BF90A stand starting.
      Don't think it will start with those comp reading. Comps that low usuall cause a misfire on these engines
    • I
      Only one way to find out, pull out the sparkplugs ans try turning the engine with the pull start.
    • I
      iang6766 replied to the thread BF60A water in oil.
      Yes, always
    • I
      iang6766 replied to the thread BF60A water in oil.
      I see no reason why you can't have both lips facing out, there 's no fluid between them and the oil pump. Looks like you're really onto...
    • I
      iang6766 replied to the thread BF60A water in oil.
      This is very useful info, interesting. I did think Honda were just grasping at straws making us use Upgraded sump bolts and increasing...
    • I
      iang6766 replied to the thread BF60A water in oil.
      Just had another thought on this. If water is being pulled up the shaft and into the oil pump, then perhaps a slinger as Mercury use on...
    • I
      iang6766 replied to the thread BF60A water in oil.
      Your theory is interesting mate. My answer is based on Honda Japan's investigation into this. I have to say though, I have rebuilt about...
    • I
      iang6766 replied to the thread BF60A water in oil.
      I have repaired lots of these, yes.You need to check your oil pump, they usually fail with water abd if it has, full rebuild is recommended.
  • Loading…
  • Loading…
Top