Logo
FULL SITE MENU

Recent content by Danny33

  1. D

    1967 Johnson 40 won’t turn over with both plugs in

    I’ve got all the help I need from this thanks
  2. D

    1967 Johnson 40 won’t turn over with both plugs in

  3. D

    1967 Johnson 40 won’t turn over with both plugs in

    I’ve given every piece of information you’ve asked for so don’t understand how I’m keeping “vital information a secret”
  4. D

    1967 Johnson 40 won’t turn over with both plugs in

    I appreciate the help I’m stumped myself
  5. D

    1967 Johnson 40 won’t turn over with both plugs in

    Got a brand new battery on it as well
  6. D

    1967 Johnson 40 won’t turn over with both plugs in

    Hi here is the model number for the engine RDSL-29E I by passed all the cables and am testing directly at the starter to eliminate any issues with wiring. Coils are new shifter is functional goes in and out of gear fine. Just can’t get it to turn over with both plugs in and also has a new starter
  7. D

    1967 Johnson 40 won’t turn over with both plugs in

    Hi everyone I recently bought a 1967 Johnson 40 but it started only turning over when you have one plug out both cylinders have a compression reading of around 120 any help would be appreciated
  8. D

    Gale sovereign 40 no spark

    I have I checked ohms on the coils and points looked fine I just ordered a kit with new points and condensers for it
  9. D

    Gale sovereign 40 no spark

    Hi everyone I’m new to the antique boat motor world and have been having a hard time getting spark on my gale 40 hp it started as one cylinder not getting spark now both are without spark any help would be greatly appreciated
  10. D

    Gale sovereign 40 not pumping water

    Ok I can get some pictures this afternoon having tribe figuring out where both tubes go
  11. D

    Gale sovereign 40 not pumping water

    Yes it did does the two copper tubes slide together
  12. D

    Gale sovereign 40 not pumping water

    Would this motor have a thermostat?
  13. D

    Gale sovereign 40 not pumping water

    Ok I believe I only had it in about 6 inches above the impeller
  14. D

    Gale sovereign 40 not pumping water

    Hi everyone I recently bought a Texas maid impala that has the original gale motor on it that runs perfectly however I am having an issue with it pumping water I’ve had the lower unit off a dozen times but still can’t get it to pump water was just looking for a little advice
See more
Back
Top