Logo
FULL SITE MENU

Recent content by bruingtonbeagles

  1. B

    j235txcrc help

    does anyone know the cylinder head bolt torque specs for this motor j235txcrc gettin ready to put new head gaskets on her,seeping water into cylinders.thanks for any info:D
  2. B

    help finding flywheel magnets

    j235txcrc pulled flywheel off and found broken magnets:mad:my question is are they still available?where can i get them and do you have to buy the whole set or can you just replace the broken ones.thanks for any help..
  3. B

    parts swap will they fit?

    i have a johnson j235txcrc,i was told i need a new reg/rectifier,a new timing base and a new stator by a local shop.my question is i bought a evinrude e150txcca for parts because i was told all the parts are interchangeable.can anyone tell me if my evinrude electrical parts stated above will...
  4. B

    power tilt & trim issues 1984 235hp

    well guys i am still working on my newly aquired 1984 johnson 235.took the boat out today and had same results as first trip.first trip out motor would not trim up under thottle,stop the boat and would trim fine.trim motor up and then accelerate and motor would slam back down to the...
  5. B

    please help with wiring issue 1985 235hp

    hello i have a 85 model 235 johnson on a 22ft center console i just purchased,the boat has several years of giddjets and gaddjets that have been wired up to create a mess,i attempted to fix the wiring problem today by eliminating all the "unnecassary" jumble of wires,well now the motor cranks...
  6. B

    johnson/evinrude 235 #s dont match?

    hello everyone i am new to this board but have checked it out the past few nights and it seems to be a great place to get some info.ok so i bought a new to me boat with a johnson 235 outboard or so i was told.my question is on some previous posts here i seen where you need to check the model and...
See more
Back
Top