Logo
FULL SITE MENU

Recent content by BigGTP63

  1. B

    Fuel leaking from vapor separator

    Update. Bad pump no fuel pressure and float was 1/2 full of fuel. Replaced pump,float, needle an psi regulator. Runs good now but now I get 1 long beep ( roughly 3 seconds long) after about 15 minutes of running on the water 🤷‍♂️
  2. B

    2013 40elpt. Random long beep off and on.

    I did just replace HP fuel pump , float , needle and psi regulator. Run great but that's when alarm problem began.
  3. B

    2013 40elpt. Random long beep off and on.

    Think this is overheat alarm. New water pump, thermostat and sending unit. Intake is clear, good water stream just slightly warm. Any suggestions???
  4. B

    Year and model help

    Thank you
  5. B

    Year and model help

    For parts but I found a paperwork it's 2013. Having trouble with the VST fuel run out the bottom when you pump the bubble, no start. Got to get an adapter to check the fuel pressure.
  6. B

    Fuel leaking from vapor separator

    Will that cause NO start.?? I'm concerned it may be fuel pump diagram since no start I have not checked the pressure need to get adapter for my automotive fuel gauge
  7. B

    Fuel leaking from vapor separator

    Model# 1a40413bz Serial # 1c233803
  8. B

    Fuel leaking from vapor separator

    I have a 40hp ELPT EFI. What's running fine shut it off 30 minutes later would not restart bubble lost its prime pumping bubble fuel runs out of the bottom of what I believe to be the vapor separator.. if I clamp off a line that dumps out the bottom of the engine it will crank up an idle for...
  9. B

    Year and model help

    1C233803. 40hp ELPT??? Year model
See more
Back
Top