Logo
FULL SITE MENU

Recent content by 92 johnson

  1. 9

    92 johnson **** shaft

    I adjusted it to the hole depth on the shaft. Adjusted the cable to fit Went to the boat ramp and tested it forward worked ok, when in reverse it was clicking and jumping in and out of gear. Tried adjusting the cable & no matter which direction it would not ever work in both gears properly. Or...
  2. 9

    92 johnson **** shaft

    That is the measurement I've been using. The shift lever never seems to line up with the shaft when in the same gear selection. It's always about half the diameter of the screw hole off. Is there a adjustment needed on the controls
  3. 9

    92 johnson **** shaft

    J200stlens is the model number
  4. 9

    92 johnson **** shaft

    After resealing the lower unit and replacing water impeller I did not have reverse. Took it apart and checked the shaft to see if it turned on me and reinstalled and now do not have forward
  5. 9

    92 johnson 200 J200STLENS cuttting out

    So I should probably do a Compression check to Rule out head or gasket issues? Water pump ant thermostats are 3 years old but there is good water pressure when it's running. Temp sensor is disconnected and grounded out due to unavailability not sure if that would have any like issues?
  6. 9

    92 johnson 200 J200STLENS cuttting out

    Runs great at idle and lower speeds. When I get to 3500-4000 Rpms it starts cutting out sometimes at little higher rpm depending on water conditions. Removed the VRO pump and replaced fuel pump that did not help.
See more
Back
Top