MarineEngine.com does not offer troubleshooting assistance or repair advice by email or by telephone.
You are invited to join our public Boat Repair Forum to seek assistance from other members.
You may also visit the Boat Motor Manuals section of our site to obtain a service manual.
That top ring is the problem-----As the piston / ring / cylinder wear the side clearance INCREASES and the ring is loose in there.-----At 5000 + RPM it breaks !!----New pistons from WISECO are one solution.
That top ring is the problem-----As the piston / ring / cylinder wear the side clearance INCREASES and the ring is loose in there.-----At 5000 + RPM it breaks !!----New pistons from WISECO are one solution.
I just got the engine block from machine shop. Had to bore .030 to clean up cylinder. Getting ready to order complete kit with over size pistons, all bearings, seals, rod bolts and gaskets. I found a good used head for 80 bucks. After the carb kit, thermostats and water pump kit I should have around 1,200 or 1,300 in it.
the kit came with ThreeBond 1184.
Is this to seal crank case to block, or should I find the gel seal that Racerone said to use?
It is a great antifriction coating. Just about all the NasCar pistons get it. We put that coating on all the Ford, Chrysler, Toyota, Polaris, steel heavy duty truck pistons and Mercury Marine pistons. If the parts are processed properly before the coating is applied, it will not come off. It will wear down on the skirt center vertically from the up and down stroking. If the coating comes off and scars my cylinder walls, me and the supplier that I purchased them from are going to have a conversation. Sorry I'm rambling on.Right, of course they are placed exactly into position to direct water circulation. I like those pistons. Are the rings chamferred to increase cylinder wall pressure? To me, that theory is like a double edge sword. Like dah!.....why is that top ring so far down?