" To shift these motors, the e
" To shift these motors, the engine must be running, (pump Pressure)moves clutch-dog, ie name hydro-electric. to test switch, disconnect two wires from engine harness that go dowwn to foot (located at rear of engine by hood latch. One green, one blue, w/ knife type terminals inside rubber sleeve. Forward gear should have 12v on NO wires, Neutral, 12v on 1 wire, reverse 12v on both wires. this will determine switch or foot problems. Soleinoids should ohm out @ 16 ohms.
these units are very dependable if the oil is kept clean. 75W gear oil max. (no 90-140) "