No water reaches the engine,the impeller seames OK.
But the copper tube has a drilled hole of 3 mm,and there are also one 3 mm hole drilled
in the motor block close to the copper tube.
The cooling water is flowing out of these holes.
What is the function of the holes?
Cant I just block the holes to increase the water pressure?
But the copper tube has a drilled hole of 3 mm,and there are also one 3 mm hole drilled
in the motor block close to the copper tube.
The cooling water is flowing out of these holes.
What is the function of the holes?
Cant I just block the holes to increase the water pressure?