Logo
FULL SITE MENU

Search results

  1. I

    Chrysler-1968 Hemis in a 32 foot Aluminum FIREBOAT

    These are some older fotos...
  2. I

    Chrysler-1968 Hemis in a 32 foot Aluminum FIREBOAT

    Seriously guys. I don't have all the details just yet. Also I am looking for KNOWLEDGEABLE input. My friend has the boat, has owned it for 15 years and has a clean title. I haven't seen the boat in 10 years. It sits on a trailer and is GUTTED.....with the exception of the mechanicals....the...
  3. I

    Swapping an Alphha 1 for an MR

    I have found/purchased a complete Alpha 1 from a 5.0 Merc(including the inner Transom plate and trim pump etc) So,...the problem is this..... the boat is a 1972 SlickCraft. It has a 1972 Ford (Merc) 302 with an MR drive...that uses a 3 piece "Y" exhaust pipe... The gasket/bolt pattern...
  4. I

    Crusader 270 rebuild LOW compression

    I had my Crusader 270 Hp 's rebuilt my a Marine specialty shop here in Michigan. The shop ran the engines in on a wet test stand prior to my taking them..... After my reinstall, I ran them for 20 minutes at 2000rpm prior to launch......Then,I ran the boat 120 miles at various speeds on the...
  5. I

    Ignition (coil)

    I SHOULD know this , but alas age has me looking thru cobwebs. Having just rebuilt my smallblocks , it's time to reinstall them. 1st, I have been running without ballast resistors and a Mallory electronic distributor for nearly 15 years. While wrenching, I somehow noticed that I have 9V coils...
Back
Top