Logo
FULL SITE MENU

Search results

  1. B

    1970 Mercury 70HP carbs wont stop leaking?

    Hey ya'll, I have a 1970 Mercury outboard that I have put new needle and seat assemblies in, and a new fuel pump, and I can not get the carbs to stop leaking? Someone said it may possibly be the reed valves are weak? The motor runs great at wide open throttle but as soon as you throttle down it...
  2. B

    1996 130 hp shuts off under load??

    So i have a 1996 Evinrude 130 V4 model# E130TLEDM serial# G04186442 I have replaced the VRO and plugs fuel filter vaor check valves and here in lies the problem. Hooked to a fresh water flusher runs great, take it to the water and it starts out great until you go to throttle. from about half...
  3. B

    2002 60 hp 4stroke EFI won't stay running

    Here we go, I have a 2002 60 4stroke EFI that is having problems staying running. Put fresh fuel in it and changed the fuel filter, along with Merc Dry Fuel. That seemed to help a little! But if you put it in gear and give throttle it dies? Thinmking maybe low side fuel pump? What'cha think? THANKS
  4. B

    Mercury 850 upper end cap bearing

    OK I have a 1970's 850 Merc with a bad upper end cap bearing, dry to the bone! It has came apart and chewed up the cage. My question is...can I remove the upper end cap without splitting the case? And is it woth doing?because some of the metal could've gotten into the engine? Or do the 4 bolts...
  5. B

    130 won't satrt after waterpump change?

    OK guy's changed a water pump, plugs,fuel filter and engine/lower oil, on a 130 4 stroke and insatlled 2 new batteries with a new Perko switch and low and behold she will not turn over?? If i turn the key to the run position and jump the solenoid starts right up. I read that the O2 sensor can...
Back
Top