Logo
FULL SITE MENU

Search results

  1. T

    RC Box & gauges for my unit? 115A2 Serial number provided

    Hey guys, new Tohatsu owner here! Love this 115A2 motor... Can anyone pass along any info that my serial number would help to provide? I want to get the newest RC Box and gauges for my motor that will give me the most data possible .... Can this motor pass NMEA 2000 data--fuel flow, etc? I...
  2. T

    Worried about a black plug of four and very rough idle f150 2011

    2011 Yamaha f150 4-strokes Man, I am super worried about what a leak-down test may show tomorrow. Both motor(s) have 400 hours on them. -Both 2011 year.... I have a rough idle on my starboard motor. The second plug from the top was dark and other 3 were nearly white. Coil sparking fine...
  3. T

    New to me f225's

    Would some one be willing to tell me what parts I need to get fuel management gauges & senders for my motors? one is a 2002 one is a 2006 i realize they are worlds apart, but I'm excited to be part of the family now. :rolleyes:
  4. T

    550 hours on BF150's--what to do at this point.

    I've been the original of both motors since new in 2009. Other than an alternator, these two motors have been flawless. I did the thermostats and VST's, about 100hours ago. But other than that, I've not done anything to these motors. I'm ready to do whatever they need, but honestly, throwing...
  5. T

    Lost either voltage regulator or alternator -- a question about a fuse?

    Last summer I was slow trolling and an alarm went off on my starboard 2008 BF150. A quick glance at my constant led volt meter and it was climbing past 16vdc. So, immediately I shut off the motor. On and off throughout the morning it was clear with a minute or so, the voltage would climb from...
  6. T

    Auxialary charging lead?

    I did that..... i have twins too.
  7. T

    08 BF150 voltage too high and warning buzzer

    I had just finished making a 1.5 hour run at or about 4400 rpms and (twin outboard 150's) my Starboard motor started beeping and MY LED VOLTMETER was slowly climbing! Within about 10 seconds it had climbed up to about 16.2 VDC. Obviously, I shut down the motor and throughout the day day I would...
  8. T

    My first scare on a BF150 with 294 hours

    I am not sure, but I think my thermostat was stuck closed at start up. With about 45 seconds I noticed that there was no peeing! So I quickly climbed my ladder and ran into the cabin and shut that starboard engine off. Then I went back out to the motor and felt the aft right rear of the block...
  9. T

    BF150A Options for Fuel Monitoring

    You know what's funny though...... The only REAL data will be the GPH. You won't get MPG correctly. Honda in their infinite wisdom uses a pitot (tube/air thingy) to figure your physical distance. So. it isn't very accurate. You better off getting a crappy lowrance fuel sender and hooking...
  10. T

    Anyone seen this issue with a bf225?

    http://www.thehulltruth.com/boating-forum/350262-things-not-miss-maintaining-your-honda-bf200-bf225s.html
  11. T

    What protocol for pair of digital 2008 BF 150 hp's

    I have a pair of BF150's (2008) and want to know what protocol the engine (fuel) data communicates on. I know I don't have N2K, due to age and serial numbers. I want to try and access the data....somehow.
  12. T

    Flushing

    I decided that due to low water prssure here at the coast, rather than flushing with muffs, I would use a horse water trough. They're made by Rubbermaid and are nice and tall. Super easy, raise fill and lower BF150's each, one at a time, 15 minutes and Im done. Here's the question. What...
Back
Top