Logo
FULL SITE MENU

Search results

  1. R

    fuel problem 1990 115 hp

    I have a 90 merc 115 newly rebuilt that runs ok at low rpm's but when you try to go over 3800rpm's it starts to run out of gas. pump the bulb and it runs again and if you come to a stop it will die after starving which makes sense however, I pump the bulb up with the hose off the motor and it...
  2. R

    pictures

    where are these "thousands of pictures" seloc claims are in these manuals. There are few at best in the mercury manual.:(
  3. R

    1991 merc 115 hp oil line routing and general pictures

    I tore this engine "91 115" down about 2 months ago and had a hard time gettin a couple of parts. I finally recieved my parts and assembled the engine but have forgot the oil line routing. seloc doesnt give any total views of the engine. does anyone know a good resource for making sure all of...
  4. R

    1991 115hp crankcase install

    I'm a little confused as to how much and where exactly do you apply the loctite 518 gasket maker on both the block and the crankcase cover. Do you apply the sealer directly to the outside of the main bearings? Is there a video? If i'm correct it takes quite a lot af gasket maker do perform the...
  5. R

    Bearing installation 1991 115 hp

    "when installing main bearings on a 1991 mercury 115 4 cylinder, is it ok to use hilton hyperlube on the bearings in order to get them to stay in place. Also, is it proper to use two stroke oil to install the piston assy in cylinder bore? thanks, Ron"
  6. R

    Removing intake 1990 115 hp 2 stroke

    "anyone know if you must remove the carb mounting studs on the intake in order to remove the intake or reed valves? I'm have a hard time breaking loose the manifold from the crankcase cover. thanks, Ron"
  7. R

    Powerhead repairs

    does the powerhead have to be does the powerhead have to be removed to rebuild it? or can repairs to the cylinders be made with the powerhead in place?
Back
Top