Logo
FULL SITE MENU

Search results

  1. A

    Motor wonbt start only a single click sound

    I have a 91 Glasstron with a V I have a 91 Glasstron with a V6 4.3 liter Alpha 1 with a thunder bolt ignition. When I tried to start it for the first time this year all it did was make a single clicking noise every time I turned the key. The noise is not coming from the starter; I think it is...
  2. A

    Aq131a Backfires

    The motor has been back firing The motor has been back firing at low to mid range RPM. Once I get the motor to go full throttle the back firing stops. Is this a timing issue or should I consider a carb rebuild/tune up?
  3. A

    AQ131A Running hot HELP

    "Does anyone have any idea whe "Does anyone have any idea where to start looking for an over heating problem. I had it on the lake yesterday, it ran fine, it just ran hot. By the time I made it back to the boat ramp the engine was around 240 degrees. When I first had it out it stayed around...
  4. A

    AQ131A normal running temp

    Does anybody have an idea of w Does anybody have an idea of what the normal running temp is for a AQ131a? Mine runs a little over 200 degress F. If it should run cooler what steps should I take to make this happen.
  5. A

    AQ131a275 over heating

    I ran my boat through a shallo I ran my boat through a shallow area in a lake and bottomed out. I sucked up alot of mud. I checked the impeller and it needs replacing (misses 3 teeth). My question is where should I look for a new impeller and what is the exact part number? Also how would I go...
  6. A

    Aq131a running sluggish

    "When I put the throttle down "When I put the throttle down all the way the rpm's stay very low and don't climb. The boat just does not want to get out of the hole. On two seperate occasions the boat shot out of the hole only to revert back to the same sluggish RPM's, this happened after I...
  7. A

    AQ131A bogging downrunning hot

    "The engine is seems to be bog "The engine is seems to be bogging down or not getting up to speed properly. While going forward the RPM's don't get up, however I put it in reverse and the RPM's are fine. I had the throttle wide open on the lake and it never got out of the hole. Only twice did...
  8. A

    AQ131A coolant hose replacement

    "I have an AQ131A. It develope "I have an AQ131A. It developed a pin hole leak in the large hose that runs from the heat exchanger to the water circulator (water pump). I can not for the life of me locate a part number, a picture of the hose or a dealer that can get one. Does anybody have any...
Back
Top