Logo
FULL SITE MENU

Search results

  1. D

    200 Evinrude 1989 driveshaft play

    "Looking for the source of a k "Looking for the source of a knock that I hear at idle both in and out of gear. I dropped the lower unit and noticed that I can move the driveshaft up and down about 2mm. There is also some rotational play in the propshaft when in gear. Is this normal? I...
  2. D

    1989 200 Evinrude small hole

    "What is this small hole for? "What is this small hole for? This is a rebuilt block that I purchased. http://i114.photobucket.com/albums/n241/TDOC2004/PDRM5703.jpg""
  3. D

    200 Evinrude Cylinder Heads

    On my rebuilt powerhead for my On my rebuilt powerhead for my 1989 Evinrude 200XP the port cylinder head has casting number 333809-4 and the starboard is 333809-3. Yet BRP parts shows only 1 part # for both heads(0397860). They look identical to me. The heads I kept off the old powerhead were...
  4. D

    Plug wires

    "I recently ordered some repla "I recently ordered some replacement plug wires for my 1989 200 Evinrude. The new wires are spiral wound mag core, but the original wires were stranded tinned copper core. The mag cores are showing 462 ohms for a 9" wire. Are these wires equivalent?"
  5. D

    150 Verado lost gauges after recal

    "Just had this motor in for a "Just had this motor in for a calibration update after receiving a notice from Merc. Hopefully it cured the false alarm issues. But now none of my analogue gauges are working. Everything appears to still be connected properly and the gauges power up at keyup, but...
  6. D

    200 Evinrude stator issue

    "This is a new stator. Looks "This is a new stator. Looks to me that the power coil is heating up(see pics). The coil can be moved around on its core a little as well, but it may have come that way. Looked like there was an issue with the previous stator as well(last pic). Power Pack is new...
  7. D

    200 Evinrude Stator part number

    Can anyone confirm the corrrec Can anyone confirm the corrrect part # for a stator for a 1991 Evinrude 200XP. Ser # C7242270 Thanks
  8. D

    Low WOT RPM on 1989 200 Evinrude

    This motor has been completely This motor has been completely redone. Everything is new other than the rectifier which was replaced a few years ago after being fried by an onboard charger. Power is down a little and wot rpm is 5700-5800 with the same prop that used to go to 6400+ if I let...
  9. D

    1989 200 Evinrude timing

    "I'm trying to setup the t "I'm trying to setup the timing on my rebuilt powerhead. Seems to want to be too far advanced. I basically have to have the adjustment screw for idle timing backed out almost all the way to be anywhere near spec. And when trying to set full advance without the...
  10. D

    1989 Evinrude 200XP

    "Long story. Not a good start "Long story. Not a good start to fishing season. Purchased this engine new in 1991. Lost pistons 1 & 2 the 1st time I put it in the water after picking it up from the dealer-new powerhead. After 75 hours same thing due to broken, very worn crank seals. Always...
Back
Top