Logo
FULL SITE MENU

Recent content by Tonisher

  1. T

    No spark aq130c/270

    Here the situation bought the boat a couple months back. I replaced fuel filter, plugs and wires, oil and filter. I fix so other minor issues with help on this forum. I took the boat out ran great. I took the boat out again for a 3 hours everything was great until the motor died. I pulled back...
  2. T

    Oil cooler O-rings not sealing

    Hey everybody. I have an issue for some reason the oil cooler o-rings are not sealing properly. I was wondering if anybody has come across this in the past. Both lines that go to the oil cooler where leaking when I bought the boat. The boat has been sitting for 5 years. I have replace the inlet...
  3. T

    AQ130C /270 "Problem"

    So yesterday I replace the impeller, and the O-ring on the inlet to the oil cooler (the line runs to the water pump impeller. I notice that one of the carb's was leaking so I took off the air cleaner housing to get a better look (upper gasket). I started the motor on muffs it took a long...
  4. T

    Aq130c / b20 / 270 help!!!

    Thank for the operator's manual & the workshop manual. I felt like i was hitting a wall until i found this site. Thank again for all the advice and resources. Tony
  5. T

    Aq130c / b20 / 270 help!!!

    the problem im having is i recently bought a 1972 glastron v164 and im trying to get her river ready. There is a pipe that goes from the the water pump down to the lower part of th e engine the o-ring is leaking. There is also a fuel pipe that go down to the same lower part of the engine it is...
See more
Back
Top